REAR SPEED SENSOR INSTALLATION


  1. INSTALL REAR SPEED SENSOR LH


    1. w/ Skid Control Sensor Wire:


      1. Install a new O-ring to the rear speed sensor.

      2. A01BF6B

        Install the rear speed sensor with the bolt.

        Torque:
        8.5 N*m  { 87 kgf*cm, 75 in.*lbf }

        Note

        Prevent foreign matter from attaching to the sensor tip.

      3. Connect the connector.

    2. w/o Skid Control Sensor Wire:


      1. Install the rear speed sensor LH with the bolt.

        A01BAL2
        Torque:
        8.5 N*m  { 87 kgf*cm, 75 in.*lbf }

        Note

        Prevent foreign matter from attaching to the sensor tip.

      2. Attach the 4 clamps.

      3. Connect the connector.

  2. INSTALL REAR SPEED SENSOR RH


    1. w/ Skid Control Sensor Wire:

      Tech Tips

      Install the RH side following the same procedures as the LH side.

    2. w/o Skid Control Sensor Wire:


      1. Install the speed sensor RH with bolt.

        A01BBDO
        Torque:
        8.5 N*m  { 87 kgf*cm, 75 in.*lbf }

        Note

        Prevent foreign matter from attaching to the sensor tip.

      2. Install the 2 harness clamps with the 2 bolts.

        Torque:
        8.0 N*m  { 82 kgf*cm, 71 in.*lbf }

      3. Attach the 3 clamps.

      4. Connect the connector.

  3. INSTALL REAR WHEEL

    Torque:
    100 N*m  { 1020 kgf*cm, 74 ft.*lbf }

  4. CHECK SPEED SENSOR SIGNAL

    Click here