ANTI-LOCK BRAKE SYSTEM PRECAUTION

Note

When disconnecting the battery terminal, initialize the following system after the terminal is reconnected.

System See procedure
Power window control system

Click here


  1. IGNITION SWITCH EXPRESSION

    Tech Tips

    The type of ignition switch used on this model differs according to the specifications of the vehicle. The expressions listed in the table below are used in this section.

    Expression Ignition Switch (Position) Engine Switch (Condition)
    Ignition Switch off LOCK Off (Lock)
    Ignition Switch ACC ACC On (ACC)
    Ignition Switch ON ON On (IG)
    Engine Start START On (Start)

  2. TROUBLESHOOTING PRECAUTION

    Tech Tips

    The anti-lock brake system includes the ABS and BA Click here.

    Note


    • When there is a malfunction in the terminal contact points or installation problems with parts, removing and installing the suspected problem parts may return the system to normal, either completely or temporarily.

    • In order to determine the malfunctioning area, be sure to check the conditions at the time the malfunction occurred, such as by the DTC output and the freeze frame data output, and record it, before disconnecting each connector or removing and installing pats.

    • Be sure to remove and install the brake actuator and each individual sensor with the ignition switch off unless specified otherwise in the inspection procedure.

    • When removing and installing the brake actuator and each individual sensor, be sure to check that the normal display is output in Test Mode inspection and DTC output inspection after installing all the parts.