TORSION BAR SPRING REMOVAL


  1. REMOVE FRONT WHEEL

  2. REMOVE FENDER APRON MUDGUARD SEAL


    1. A01BA58E01

      Remove the 4 clips and fender apron mudguard seal.

  3. REMOVE TORSION BAR SPRING


    1. A01BD3DE01

      Slide the dust cover on the anchor arm side and put matchmarks on the torsion bar spring, anchor arm, and front suspension torque arm.

    2. Hold the anchor arm adjust nut and remove the anchor arm lock nut with a wrench (22 x 24 mm).

    3. A01BHZ6E01

      Measure dimension A (to be used as a reference dimension in later steps) of the anchor arm adjusting hexagon bolt and note down the length.

    4. Loosen the anchor arm adjust nut to free the torsion bar spring.

    5. A01BH0TE02

      Remove the following parts from the anchor arm.


      1. Anchor arm adjust nut. (Part A)

      2. Anchor arm adjust seat. (Part B)

      3. Anchor arm adjusting hexagon bolt. (Part C)

      4. Anchor arm swivel. (Part D)

    6. Remove the anchor arm and torsion bar spring.

    7. Remove the torsion bar dust cover from the torsion bar spring.

  4. REMOVE FRONT SUSPENSION TORQUE ARM


    1. A01BFTEE01

      Remove the 2 bolts and torque arm from the front suspension upper arm.