REAR AXLE SHAFT REMOVAL


  1. REMOVE REAR WHEEL

  2. DRAIN BRAKE FLUID

  3. REMOVE REAR BRAKE DRUM SUB-ASSEMBLY


    1. A01BF75E01

      Release the parking brake lever, and remove the brake drum.

      Tech Tips

      If the brake drum cannot be removed easily, perform the following steps.

    2. Remove the hole plug and insert a screwdriver through the hole in the backing plate, and hold the automatic adjusting lever away from the adjuster.

    3. Using another screwdriver, contract the brake shoe adjuster by turning the adjusting wheel.

  4. REMOVE REAR AXLE BRAKE DRUM GASKET

  5. REMOVE AUTOMATIC ADJUST LEVER


    1. A01BDIP

      Remove the automatic adjust lever and the tension spring.

  6. SEPARATE PARKING BRAKE SHOE STRUT SET


    1. A01BBSLE01

      Using SST, remove the upper side tension spring from the brake shoe.

      SST
      09703-30011

  7. REMOVE FRONT BRAKE SHOE


    1. A01BGIR

      Using a needle-nose pliers, remove the anchor side tension spring.

    2. A01BANUE01

      Using SST, remove the cup, shoe hold-down sprig and pin.

      SST
      09718-00011
    3. A01BDX5E01

      Remove the parking brake shoe lower strut.

    4. Separate the brake shoe return spring, and remove the front brake shoe.

  8. REMOVE REAR BRAKE SHOE


    1. A01BHHPE01

      Using SST, remove the cup, shoe hold-down sprig and pin.

      SST
      09718-00011
    2. A01BBA3

      Disconnect the parking brake cable No. 3 and remove the rear brake shoe.

  9. REMOVE PARKING BRAKE SHOE STRUT SET


    1. A01BFWHE01

      Using a screwdriver, remove the C-washer, brake shoe lever, rear cushion lever and brake shoe strut set from the brake shoe.

    2. Remove the adjusting bolt and tension spring from the brake shoe strut set.

  10. SEPARATE PARKING BRAKE CABLE ASSEMBLY NO.3


    1. A01BAUJ

      Remove the 2 bolts and separate the parking brake cable assembly No.3 from the rear brake backing plate.

  11. REMOVE REAR WHEEL BRAKE CYLINDER ASSEMBLY


    1. A01BH8I

      Using a union nut wrench, disconnect the brake tube, use a container to catch brake fluid.

    2. Remove the 2 bolts and wheel cylinder.

  12. SEPARATE REAR SPEED SENSOR (w/ ABS)


    1. A01BF6B

      Disconnect the connector.

    2. Remove the bolt and rear speed sensor.

      Note

      Prevent foreign matter from attaching to the sensor tip.

    3. Remove the O-ring from the rear speed sensor.

  13. REMOVE REAR AXLE SHAFT WITH BACKING PLATE


    1. A01BG26J01

      Remove the 4 nuts and rear axle shaft with backing plate.

      Note


      • Be careful not to damage the rear axle shaft oil seal.

      • Be careful not to damage the skid control rotor rear.

  14. REMOVE BEARING RETAINER O-RING


    1. Remove the bearing retainer O-ring from the rear axle housing assembly.

  15. REMOVE REAR AXLE SHAFT OIL SEAL


    1. A01BB6AE01

      Using SST, remove the rear axle shaft oil seal from the rear axle housing assembly.

      SST
      09308-00010