FRONT AXLE HUB ON-VEHICLE INSPECTION


  1. REMOVE FRONT WHEEL

  2. INSPECT FRONT AXLE HUB RUNOUT


    1. A01BBYS

      Using a dial indicator, check for runout on the surface of the front axle hub outside the hub bolt.

      Maximum
      0.07 mm (0.0028 in.)

      Note

      Ensure that the dial indicator is set at right angles to the measurement surface.

      If runout exceeds the maximum, replace the front axle hub.

  3. INSPECT FRONT AXLE HUB BEARING LOOSENESS


    1. A01BAIG

      Using a dial indicator, check for looseness near the center of the front axle hub.

      Maximum
      0.05 mm (0.0020 in.)

      Note

      Ensure that the dial indicator is set at right angles to the measurement surface.

      If looseness exceeds the maximum, replace the bearing.

  4. INSTALL FRONT WHEEL

    Torque:
    100 N*m  { 1,020 kgf*cm, 74 ft.*lbf }