SHIFT LEVER SHAFT HOUSING DISASSEMBLY


  1. REMOVE SELECT OUTER LEVER LOCK PIN


    1. A01BH2H

      Loosen the nut of the select outer lever lock pin until the top of the nut becomes flush with the end of the lock pin.

    2. A01BBVL

      Using a brass bar and a hammer, disengage the select outer lever lock pin.

    3. Remove the nut, washer and select outer lever lock pin from the shift lever shaft housing assembly.

  2. REMOVE SELECT OUTER LEVER


    1. A01BF3N

      Remove the select outer lever and washer from the select lever shaft sub-assembly.

  3. REMOVE SELECT LEVER SHAFT SUB-ASSEMBLY


    1. A01BD5R

      Remove the select lever shaft sub-assembly from the shift lever shaft housing.

  4. REMOVE LEVER LOCK PIN NO.2


    1. A01BDDX

      Loosen the nut of the lever lock pin No.2 until the top of the nut becomes flush with the end of the lock pin.

    2. A01BC2U

      Using a brass bar and a hammer, disengage the lever lock pin No.2.

    3. Remove the nut, washer and lever lock pin No.2 from the shift lever shaft housing assembly.

  5. REMOVE SHIFT OUTER LEVER NO.1


    1. A01BGSV

      Remove the shift outer lever No.1 from the shift and select lever shaft.

  6. REMOVE SHIFT LEVER BOOT


    1. A01BFC6

      Remove the shift lever boot from the shift lever shaft housing.

  7. REMOVE SHIFT AND SELECT LEVER SHAFT


    1. A01BFDW

      Using a pin punch (5 mm) and a hammer, remove the shift lever shaft set slotted pin.

      Note

      Be careful not to damage the shift and select lever.

    2. A01BC1ZE01

      Pull out the shift and select lever shaft from the shift lever shaft housing.

  8. REMOVE SHIFT AND SELECT LEVER


    1. A01BCO1

      Remove the shift and select lever, select spring seat No.1 and spring from the shift lever shaft housing.

  9. REMOVE REVERSE RESTRICT PIN SLOTTED SPRING PIN


    1. A01BE3I

      Using a hammer, drive a screw extractor into the reverse restrict pin slotted spring pin.

    2. Pull out the reverse restrict pin slotted spring pin from the shift lever shaft housing.

  10. REMOVE REVERSE RESTRICT PIN NO.1


    1. A01BGBV

      Remove the reverse restrict pin No.1 and compression spring from the shift lever shaft housing.

    2. Remove the compression spring from the reverse restrict pin No.1.

  11. REMOVE SHIFT LEVER NO.2 SHAFT OIL SEAL


    1. A01BBYV

      Using a screwdriver with its tip taped, remove the shift lever No.2 shaft oil seal from the shift lever shaft housing.

      Note

      Be careful not to damage the shift lever shaft housing.

  12. REMOVE SHIFT LEVER SHAFT OIL SEAL


    1. A01BEQO

      Using a screwdriver with its tip taped, remove the shift lever shaft oil seal from the shift lever shaft housing.

      Note

      Be careful not to damage the shift lever shaft housing.