INPUT SHAFT INSPECTION


  1. INSPECT SYNCHRONIZER RING NO.2


    1. A01BAYL

      Apply gear oil to the cone of the input shaft, and check that it does not turn in either direction while pushing the synchronizer ring No.2.

      If it turns, replace the synchronizer ring.

    2. A01BBD0

      Check the clearance between the synchronizer ring No.2 and input shaft while pushing the synchronizer ring No.2 against the cone of the input shaft.

      Standard clearance
      0.70 to 1.70 mm (0.0276 to 0.0669 in.)

      If the clearance is not within the specified values, replace the synchronizer ring No.2 with a new one.