SHIFT LEVER ASSEMBLY INSTALLATION


  1. INSTALL SHIFT LEVER ASSEMBLY


    1. A01BFSF

      Install the shift lever assembly with the 4 bolts.

      Torque:
      14 N*m  { 140 kgf*cm, 10 ft.*lbf }

  2. INSTALL TRANSMISSION CONTROL CABLE ASSEMBLY


    1. A01BCUGE01

      Install the transmission control cable assembly to the shift lever.

      Note

      Install the transmission control cable assembly so that the end section of the select cable indicated by the arrow, as shown in the side view, (A in the illustration) faces upward.

    2. A01BGLKE01

      Turn the control cable assembly adjust nut clockwise 180°. While holding the adjust nut, push in the locks.

    3. Install the control cable assembly to the shift lever.

      Note

      Make sure that the control cable assembly is firmly installed to the shift lever.

      Tech Tips

      When the cable is installed to the shift lever, the locks are released and the adjust nut rotates 180°. Then, the locks are engaged again.

  3. INSTALL INSTRUMENT PANEL FINISH PANEL LOWER CENTER


    1. A01BB5ME01

      Engage the 8 claws and install the instrument panel finish panel lower center.

  4. INSTALL SHIFTING HOLE COVER ASSEMBLY


    1. A01BF5BE01

      Manual Transmission:

      Engage the 6 claws and install the shifting hole cover assembly.

    2. Automatic Transmission:

      Engage the 8 claws and install the sifting hole cover assembly.

  5. INSTALL SHIFT LEVER KNOB

  6. INSTALL PARKING BRAKE HOLE COVER


    1. A01BF1ME01

      Engage the 6 claws and install the parking brake hole cover.

  7. INSTALL INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY NO.1


    1. A01BE86E01

      Engage the 3 claws.

    2. Install the instrument panel No.1 under cover sub-assembly with the 2 clips.

  8. INSTALL INSTRUMENT PANEL FINISH PANEL LOWER


    1. A01BHMVE01

      Engage the 4 clips (B).

    2. Install the instrument panel finish panel lower with the 2 clips (A).

  9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

  10. PERFORM INITIALIZATION

    Some systems need initialization after reconnecting the cable to the negative battery terminal Click here.