MANUAL TRANSMISSION EXTENSION HOUSING OIL SEAL REMOVAL

DRAIN MANUAL TRANSMISSION OIL
1. Remove the filler plug and gasket.
2. Remove the drain plug and gasket, and drain the oil.
3. Install the drain plug with a new gasket.
  
  Torque:
  
  37 N*m { 377 kgf*cm, 27 ft.*lbf }
REMOVE PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY (for Super Long Wheelbase)
1. Put matchmarks on both flanges.
2. Remove the 4 nuts, bolts and washers.
  
  Tech Tips
  
  If the flange connection is hard to separate, temporarily tighten one nut only and evenly tap the flange with a brass bar and hammer to separate the propeller with center bearing shaft assembly from the differential companion flange.
3. Remove the 2 bolts and center support bearing assembly No.1.
4. Remove the propeller with center bearing shaft assembly.
5. Insert SST in the transmission to prevent oil leakage.
  
  Note
  
  Do not damage the oil seal.
  1. Use the following SST for the automatic transmission.
    
    SST
    
    09325-40010
  2. Use the following SST for the manual transmission.
    
    SST
    
    09325-20010
REMOVE PROPELLER SHAFT ASSEMBLY (for Long Wheelbase)
1. Put matchmarks on both flanges.
2. Remove the 4 nuts, bolts and washers.
  
  Tech Tips
  
  If the flange connection is hard to separate, temporarily tighten one nut only and evenly tap the flange with a brass bar and hammer to separate the propeller shaft assembly from the differential companion flange.
3. Remove the propeller shaft assembly.
4. Insert SST in the transmission to prevent oil leakage.
  
  Note
  
  Do not damage the oil seal.
  1. Use the following SST for the automatic transmission
    
    SST
    
    09325-40010
  2. Use the following SST for the manual transmission
    
    SST
    
    09325-20010
REMOVE MANUAL TRANSMISSION EXTENSION HOUSING OIL SEAL
1. Using SST, remove the oil seal.
  
  SST
  
  09308-00010