INPUT SHAFT INSPECTION


  1. INSPECT SYNCHRONIZER RING NO.2


    1. A01BDHP

      Apply gear oil to the input shaft cone. Press the synchronizer ring against the input shaft cone and check that the synchronizer ring does not turn in the directions shown in the illustration.

      If it turns, replace the synchronizer ring.

    2. A01BCP4

      Using a feeler gauge, measure the clearance between the synchronizer ring No .2 back and input shaft spline end.

      Standard
      1.0 to 2.0 mm (0.0394 to 0.0787 in.)

      If the clearance is not as specified, replace the synchronizer ring No.2.

      Note

      Ensure the fine lapping compound is completely washed off after rubbing.