SHIFT LEVER ASSEMBLY INSTALLATION


  1. INSTALL SHIFT LOCK CONTROL UNIT ASSEMBLY


    1. A01BHOCE01

      Install the shift lock control unit assembly with the 4 bolts.

      Torque:
      14 N*m  { 140 kgf*cm, 10 ft.*lbf }

    2. Install the shift lock computer connector and the indicator light wire connector.

  2. INSTALL TRANSMISSION CONTROL CABLE ASSEMBLY


    1. A01BA7KE02

      Connect the cable end to the shift lock control unit.

      Note


      • Securely connect the cable end until if fits securely against the base of the pin.

      • Connect the cable end with the protrusion facing the front of the vehicle.

    2. A01BE5LE03

      Turn the nut on the transmission control cable counterclockwise unit it stops it in place.

    3. Connect the transmission control cable to the shift lock control unit housing.

      Note


      • Connect the cable outer with the protrusion on the bottom.

      • Ensure that the groove on the cable outer is securely fitted to the shift lock control unit housing.

      • Ensure that the spring is positioned as show in the illustration.

  3. INSTALL INSTRUMENT PANEL FINISH PANEL LOWER CENTER


    1. A01BB5ME01

      Engage the 8 claws and install the instrument panel finish panel lower center.

  4. INSTALL PARKING BRAKE HOLE COVER


    1. A01BF1ME01

      Engage the 6 claws and install the parking brake hole cover.

  5. INSTALL INSTRUMENT PANEL FINISH PANEL LOWER


    1. A01BHMVE01

      Engage the 4 clips (B).

    2. Install the instrument panel finish panel lower with the 2 clips (A).

  6. INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY NO.1


    1. A01BE86E01

      Engage the 3 claws.

    2. Install the instrument panel No.1 under cover sub-assembly with the 2 clips.

  7. INSTALL SHIFT LOCK RELEASE BUTTON


    1. A01BHH1

      Install the shift lock release button to the shift position indicator housing.

  8. INSTALL SHIFT POSITION INDICATOR HOUSING SUB-ASSEMBLY


    1. A01BF5BE01

      Manual Transmission:

      Engage the 6 claws and install the shifting hole cover assembly.

    2. Automatic Transmission:

      Engage the 8 claws and install the sifting hole cover assembly.

  9. INSTALL SHIFT LEVER KNOB

  10. CONNECT BATTERY NEGATIVE CABLE

  11. INSPECT SHIFT LEVER POSITION


    1. When shifting from P position only with ignition switch ON and depress the break pedal.

    2. Make sure that the shifting lever moves smoothly and can be moderately operated.

    3. When starting engine, make sure that the vehicle moves forward when shifting from N to D position and moves reward when shifting R position.

  12. ADJUST SHIFT LEVER POSITION


    1. A01BDE0E02

      Remove a clip, nut, and disconnect between the control shaft lever to transmission control cable assembly from the control shaft lever and transmission control cable bracket No.1.

    2. A01BBPPE05

      Turn the control shaft lever until stop to a clockwise direction, return the control shaft lever 2 notches to N position.

    3. A01BEYV

      Set the shift lever to N position while holding the shift lever lightly toward the R position side and install it.

      Torque:
      15 N*m  { 150 kgf*cm, 11 ft.*lbf }

      Note

      Tighten the nut with it closing up cranky.

    4. Inspect the operation condition and work.

  13. PERFORM INITIALIZATION

    Click here