ELECTRONIC CONTROLLED AUTOMATIC TRANSMISSION SYSTEM, Diagnostic DTC:P0751/62

DTC Code DTC Name
P0751/62 Shift Solenoid "A" Malfunction (Shift Solenoid Valve S1)

DESCRIPTION

The TCM uses signals from the vehicle speed sensor and direct clutch speed sensor to detect the actual gear position (1st, 2nd, 3rd or 4th gear).

Then the TCM compares the actual gear with the shift schedule in the TCM memory to detect mechanical problems of the shift solenoid valves, valve body or automatic transmission (clutch, brake or gear etc.).

DTC No. DTC Detection Condition Trouble Area
P0751/62

The gear required by the TCM does not match the actual gear when driving.

(2-trip detection logic)

  • Shift solenoid valve S1 remains open or closed

  • Valve body is blocked

  • Automatic transmission (clutch, brake or gear, etc.)

MONITOR DESCRIPTION

This DTC indicates "stuck ON malfunction" or "stuck OFF malfunction" of the shift solenoid valve S1.

The TCM commands gear shifts by turning the shift solenoid valves "ON/OFF". When the gear position commanded by the TCM and the actual gear position are not the same, the TCM illuminates the MIL and stores the DTC.

INSPECTION PROCEDURE

PROCEDURE


  1. CHECK OTHER DTCS OUTPUT (IN ADDITION TO DTC P0751/62)


    1. Connect the intelligent tester to the DLC3.

    2. Turn the ignition switch to the ON position.

    3. Turn on the tester.

    4. Select the item "Power train / ECT / DTC / Current or Pending".

    5. Read the DTCs using the intelligent tester.

      Result
      Display (DTC output) Proceed to
      Only "P0751/62" is output A
      "P0751/62" and other DTCs B

      Tech Tips


      • If any other codes besides "P0751/62" are output, perform troubleshooting for those DTCs first.

      • When not using the intelligent tester, refer to DTC CHECK / CLEAR Click here.


    B

    GO TO DTC CHART

    A

  2. INSPECT SHIFT SOLENOID VALVE S1


    1. A01BDE2E01

      Remove the shift solenoid valve S1.

    2. Measure the resistance.

      Standard resistance
      Tester Connection

      Specified Condition

      20°C (68°F)
      Solenoid Connector (S1) - Solenoid Body (S1) 11 to 15 Ω

    3. Connect the positive (+) lead to the terminal of the solenoid connector, and the negative (-) lead to the solenoid body.

      OK
      The solenoid makes an operating sound.

    NG

    REPLACE SHIFT SOLENOID VALVE S1

    OK

  3. INSPECT TRANSMISSION VALVE BODY ASSEMBLY

    OK
    There are no foreign objects on each valve.

    NG

    REPAIR OR REPLACE TRANSMISSION VALVE BODY ASSEMBLY

    OK

    REPAIR OR REPLACE AUTOMATIC TRANSMISSION ASSEMBLY