GENERATOR INSTALLATION


  1. INSTALL GENERATOR ASSEMBLY


    1. A01BFEAE01

      Install the generator assembly with the 3 bolts.

      Torque:
      43 N*m  { 438 kgf*cm, 32 ft.*lbf }

    2. Install the generator wire with the nut to terminal B.

      Torque:
      9.8 N*m  { 100 kgf*cm, 87 in.*lbf }

    3. Install the terminal cap.

    4. Connect the generator connector.

  2. INSTALL FAN & GENERATOR V BELT

    A01BH2EE02

    1. Install the drive belt to the pulleys except the drive belt tensioner pulley.

    2. Use the hexagon-shaped part indicated by the arrow in the illustration to move the tensioner pulley downward and then install the drive belt to the tensioner pulley.

      Note


      • The backside of the drive belt should face the tensioner pulley.

      • Check that the drive belt is properly set to each pulley.

    3. A01BENJE02

      After a new belt has been installed, check that the tensioner indicator mark is within range A shown in the illustration.

  3. INSTALL ENGINE SERVICE HOLE SUB COVER ASSEMBLY


    1. Install the engine service hole sub cover with the 5 bolts.

      Torque:
      13 N*m  { 133 kgf*cm, 10 ft.*lbf }

  4. INSTALL FRONT SEAT ASSEMBLY RH (for Hi-back Seat Type)

    Tech Tips

    Perform the same procedure as above on the opposite side. Click here

  5. INSTALL FRONT SEAT ASSEMBLY RH (for Low-back Seat Type)

    Tech Tips

    Perform the same procedure as above on the opposite side. Click here

  6. INSTALL FRONT DOOR SCUFF PLATE RH

  7. CONNECT NEGATIVE BATTERY CABLE

  8. INSTALL ENGINE UNDER COVER NO.1 (w/ Engine Under Cover No.1)

    Torque:
    13 N*m  { 133 kgf*cm, 10 ft.*lbf }

  9. PERFORM INITIALIZATION


    1. Some system need initialization when reconnecting the battery cable. Click here