GENERATOR REMOVAL


  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  2. REMOVE FRONT DOOR SCUFF PLATE RH

    Tech Tips

    Use the same procedure as for the LH side Click here.

  3. REMOVE FRONT SEAT ASSEMBLY RH (for Hi-back Seat Type)


    1. A01BBC8

      Move the front seat assembly fully forward.

    2. Remove the 2 bolts on the rear side of the seat.

    3. Move the front seat assembly to the rearmost position.

    4. Remove the 2 bolts on the front side of the seat.

    5. Move the front seat assembly to the center of the seat slide rail. Set the seatback in the upright position.

    6. Disconnect the front seat inner belt assembly connector.

    7. Remove the front seat assembly.

  4. REMOVE FRONT SEAT ASSEMBLY RH (for Low-back Seat Type)


    1. A01BBVJ

      Move the front seat assembly fully forward.

    2. Remove the 2 bolts on the rear side of the seat.

    3. Move the front seat assembly to the rearmost position.

    4. Remove the 2 bolts on the front side of the seat.

    5. Move the front seat assembly to the center of the seat slide rail. Set the seatback in the upright position.

    6. Disconnect the front seat inner belt assembly connector.

    7. Remove the front seat assembly.

  5. REMOVE ENGINE SERVICE HOLE COVER SUB-ASSEMBLY


    1. Roll up the carpet and remove the engine service hole sub cover.

  6. REMOVE FAN AND GENERATOR V BELT


    1. A01BERGE01

      Remove the drive belt by rotating the tensioner pulley clockwise to loosen its tension with the pulley set bolt of the tensioner.

  7. REMOVE COMPRESSOR OUTLET ELBOW


    1. A01BFP8

      Loosen the 2 hose clamps and remove the bolt and compressor outlet elbow.

  8. DISCONNECT NO. 1 AIR CLEANER HOSE


    1. A01BHN9

      Pull the stopper upward and disconnect the No. 1 air cleaner hose from the compressor inlet elbow.

  9. REMOVE AIR TUBE ASSEMBLY


    1. A01BHAO

      Loosen the 2 hose clamps.

    2. Remove the 2 bolts, air tube and No. 1 air cleaner hose.

  10. REMOVE COMPRESSOR AND MAGNETIC CLUTCH (w/ Air Conditioning System)


    1. Disconnect the connector.

    2. A01BFJ0

      Remove the 4 bolts and compressor and magnetic clutch.

  11. REMOVE NO. 2 IDLE PULLEY ASSEMBLY (w/ Air Conditioning System)


    1. A01BETHE01

      Remove the bolt and washer, then remove the No. 2 idle pulley assembly.

  12. REMOVE GENERATOR BRACKET


    1. A01BCXBE01

      Remove the 2 bolts, then remove the generator bracket.

  13. REMOVE GENERATOR


    1. A01BCVDE01

      Disconnect the generator connector.

    2. Remove the terminal cap.

    3. Remove the nut and disconnect the wire harness from terminal B.

    4. Remove the bolt and generator.