STARTER (for 2.2 kW Type) DISASSEMBLY


  1. REMOVE MAGNET STARTER SWITCH ASSEMBLY


    1. A01BAMX

      Remove the nut and disconnect the lead wire from terminal C.

    2. A01BD70

      Using a T25 "TORX" socket wrench, remove the 3 screws holding the magnet starter switch assembly to the starter drive housing.

    3. Remove the magnet starter switch assembly.

    4. Remove the return spring.

    5. A01BGE8E01

      Remove the plunger from the pinion drive lever.

  2. REMOVE STARTER YOKE ASSEMBLY


    1. A01BH1D

      Remove the 2 bolts and starter yoke assembly from the starter drive housing.

    2. Remove the cover ring from the planet carrier.

    3. A01BC4T

      Remove the plate from the planet carrier.

  3. REMOVE STARTER BRUSH HOLDER ASSEMBLY

    Note

    Do not drop the starter armature assembly.


    1. Hold the starter yoke between aluminum plates in a vise.

      Note

      Do not damage the starter yoke assembly.

    2. A01BACO

      Remove the 2 screws and starter commutator end frame cover from the starter commutator end frame.

    3. Remove the seal ring.

    4. A01BGOIE01

      Remove the slotted washer.

    5. A01BF5VE01

      Remove the washer.

    6. Remove the starter commutator end frame from the starter yoke assembly.

    7. A01BARPE02

      Remove the starter brush holder from the starter armature assembly.

      Note

      Do not pull on the rubber part.

  4. REMOVE STARTER ARMATURE ASSEMBLY


    1. A01BBD8E01

      Remove the starter armature from the starter yoke.

  5. REMOVE STARTER CLUTCH SUB-ASSEMBLY


    1. A01BHMJ

      Remove the 3 planetary gears from the planet carrier.

    2. A01BC6BE02

      Remove the starter clutch sub-assembly, pinion drive lever and cover from the starter drive housing.

    3. A01BGPGE01

      Using a screwdriver, move the pinion stop collar to the starter clutch.

    4. A01BBUOE01

      Using a screwdriver, remove the snap ring.

    5. A01BHED

      Remove the pinion stop collar and starter clutch sub-assembly from the planet carrier shaft.

  6. REMOVE PLANET CARRIER SHAFT SUB-ASSEMBLY


    1. A01BFHX

      Using 2 screwdrivers and a hammer, tap off the snap ring.

    2. Remove the washer from the planet carrier shaft.

    3. A01BFT7E01

      Remove the planet carrier shaft from the planet carrier.

    4. Remove the intermediate sealing and the 3 damper rubbers from the planet carrier.