PRE-HEATING SYSTEM (w/o DPF) ON-VEHICLE INSPECTION


  1. INSPECT ILLUMINATION DURATION OF GLOW INDICATOR LIGHT


    1. Inspect the light illumination duration.


      1. Turn the ignition switch to ON, and then measure the light illumination duration.

        Light illumination duration
        Refer to the graph.
        A01BE00E01
        Text in Illustration
        *a Light Illumination Duration *b Engine Coolant Temperature

      2. Turn the ignition switch off.

        Tech Tips

        Actual light illumination duration may vary slightly from the graph.

        If the result is not as specified, inspect the ECM, engine coolant temperature sensor, glow plug and glow relay.

  2. INSPECT PRE-HEATING


    1. Inspect the pre-heating time.

      A01BHE8E02
      Text in Illustration
      *a Pre-heating Time *b Battery Voltage

      1. Turn the ignition switch to ON. Measure how long it takes for battery voltage to be applied to the glow plugs.

        Standard Time
        Engine Coolant Temperature Specified Condition
        40°C (104°F) or higher 1 second
        Below 40°C (104°F)

        Refer to the graph

        (maximum: 21 seconds)

        If the result is not as specified, inspect the ECM, engine coolant temperature sensor, glow plug and glow relay.

      2. Turn the ignition switch off.

    2. Turn the ignition switch to START. Check that battery voltage is applied to the glow plugs.

    3. While cranking the engine, measure how long it takes for battery voltage to be applied to the glow plugs.

      Standard Time
      Engine Coolant Temperature Specified Condition
      40°C (104°F) or higher 1 second
      Below 40°C (104°F)

      Refer to the graph

      (maximum: 21 seconds)

      If the result is not as specified, inspect the ECM, engine coolant temperature sensor, glow plug and glow relay.

  3. INSPECT AFTERGLOW TIME


    1. Inspect the afterglow time.


      1. After the engine starts, measure how long it takes for battery voltage to be applied to terminals D75-15 (GREL (+)) and D70-1 (E1 (-)) of the ECM.

        Standard Time
        Tester Connection Specified Condition
        D75-15 (GREL (+)) - D70-1 (E1 (-)) Refer to the graph
        A01BFYME01
        Text in Illustration
        *a

        Component with harness connected

        (ECM)

        		 *b Afterglow Time
        *c Engine Coolant Temperature - -

        If the result is not as specified, inspect the ECM, engine coolant temperature sensor, glow plug and glow relay.