OIL FILTER INSTALLATION


  1. INSTALL OIL FILTER SUB-ASSEMBLY


    1. A01BGY6E01

      Check and clean the oil filter installation surface.

    2. Apply clean engine oil to the gasket of a new oil filter.

    3. Lightly screw the oil filter into place, and tighten it until the gasket contacts the seat.

    4. A01BF21E02

      Using SST, tighten the oil filter.

      SST
      09228-07501
      When using a torque wrench
      Tighten the oil filter.
      Torque:
      17 N*m  { 175 kgf*cm, 13 ft.*lbf }
      When not using a torque wrench
      Tighten the oil filter an additional 3/4 turn.

  2. ADD ENGINE OIL


    1. Add fresh engine oil.

      Standard Capacity
      Item Capacity
      Drain and refill without oil filter change 5.0 liters (5.3 US qts, 4.4 Imp. qts)
      Drain and refill with oil filter change 5.5 liters (5.8 US qts, 4.8 Imp. qts)
      Dry fill 6.2 liters (6.5 US qts, 5.4 Imp. qts)

    2. Install the oil filler cap.

  3. INSPECT FOR OIL LEAK


    1. Start the engine. Make sure that there are no oil leaks from the areas that were worked on.

  4. INSTALL ENGINE UNDER COVER NO.2 (for Narrow Body, w/ Engine Under Cover No.2)

    Torque:
    13 N*m  { 133 kgf*cm, 10 ft.*lbf }

  5. INSTALL ENGINE SIDE UNDER COVER RH (for Wide Body, w/ Engine Side Under Cover RH)

    Torque:
    13 N*m  { 133 kgf*cm, 10 ft.*lbf }