OIL PRESSURE SWITCHING VALVE INSTALLATION


  1. INSTALL OIL PRESSURE SWITCHING VALVE ASSEMBLY


    1. A01BC2SE02

      Apply a light coat of engine oil to the O-ring of the oil pressure switching valve.

    2. Install the oil pressure switching valve with the bolt.

      Torque:
      10 N*m  { 102 kgf*cm, 7 ft.*lbf }

      Note

      Make sure that the O-ring is not cracked or jammed when installing the oil pressure switching valve.

    3. Connect the oil pressure switching valve connector.

  2. ADD ENGINE OIL


    1. Add new engine oil.

      Standard Oil Grade
      Item Oil Grade Oil Viscosity (SAE)
      w/ DPF

      ACEA C2

      (Using engine oil other than ACEA C2 may damage catalytic converter)

      - 0W-30

      - 5W-30
      w/o DPF

      G-DLD1, API CF-4, CF or ACEA B1

      (You may also use API CE or CD)

      - 5W-30

      - 10W-30

      - 15W-40

      - 20W-50
      Standard Capacity (w/ DPF)
      Item Fill Amount
      Drain and refill without oil filter change 6.6 liters (7.0 US qts, 5.8 Imp. qts)
      Drain and refill with oil filter change 6.8 liters (7.2 US qts, 6.0 Imp. qts)
      Dry fill 7.5 liters (7.9 US qts, 6.6 Imp. qts)
      Standard Capacity (w/o DPF)
      Item Fill Amount
      Drain and refill without oil filter change 6.8 liters (7.2 US qts, 6.0 Imp. qts)
      Drain and refill with oil filter change 7.0 liters (7.4 US qts, 6.2 Imp. qts)
      Dry fill 7.7 liters (8.1 US qts, 6.8 Imp. qts)

    2. Install the oil filler cap.

  3. INSPECT FOR OIL LEAK


    1. Start the engine. Make sure that there are no oil leaks from the areas that were worked on.

  4. INSPECT ENGINE OIL LEVEL


    1. Warm up the engine, stop the engine and wait for 5 minutes.

    2. Check that the oil level is between the upper level and lower level of the engine oil level dipstick. If the oil level is low, check for leakage and add oil up to the upper level of the engine oil level dipstick.

      Note

      Do not fill engine oil above the full level mark.