OIL PRESSURE SENSOR INSTALLATION


  1. INSTALL OIL PRESSURE SENDER GAUGE ASSEMBLY


    1. Apply adhesive to 2 or 3 threads of the oil pressure sender gauge.

      Adhesive
      Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent

      Note

      Do not apply adhesive to the oil inlet port of the oil pressure sender gauge.

    2. Using a 27 mm deep socket wrench, install the oil pressure sender gauge.

      Torque:
      15 N*m  { 153 kgf*cm, 11 ft.*lbf }

      Note

      Do not start the engine for at least 1 hour after installation.

    3. Connect the oil pressure sender gauge connector.

  2. ADD ENGINE OIL


    1. Add new engine oil.

      Standard Oil Grade
      Item Oil Grade Oil Viscosity (SAE)
      w/ DPF

      ACEA C2

      (Using engine oil other than ACEA C2 may damage catalytic converter)

      - 0W-30

      - 5W-30
      w/o DPF

      G-DLD1, API CF-4, CF or ACEA B1

      (You may also use API CE or CD)

      - 5W-30

      - 10W-30

      - 15W-40

      - 20W-50
      Standard Capacity (w/ DPF)
      Item Fill Amount
      Drain and refill without oil filter change 6.6 liters (7.0 US qts, 5.8 Imp. qts)
      Drain and refill with oil filter change 6.8 liters (7.2 US qts, 6.0 Imp. qts)
      Dry fill 7.5 liters (7.9 US qts, 6.6 Imp. qts)
      Standard Capacity (w/o DPF)
      Item Fill Amount
      Drain and refill without oil filter change 6.8 liters (7.2 US qts, 6.0 Imp. qts)
      Drain and refill with oil filter change 7.0 liters (7.4 US qts, 6.2 Imp. qts)
      Dry fill 7.7 liters (8.1 US qts, 6.8 Imp. qts)

    2. Install the oil filler cap.

  3. INSPECT FOR OIL LEAK


    1. Start the engine. Make sure that there are no oil leaks from the areas that were worked on.

  4. INSPECT ENGINE OIL LEVEL


    1. Warm up the engine, stop the engine and wait for 5 minutes.

    2. Check that the oil level is between the upper level and lower level of the engine oil level dipstick. If the oil level is low, check for leakage and add oil up to the upper level of the engine oil level dipstick.

      Note

      Do not fill engine oil above the full level mark.

  5. INSTALL NO. 2 ENGINE SERVICE HOLE COVER


    1. Install the No. 2 engine service hole cover with the 3 bolts.

      Torque:
      9.0 N*m  { 92 kgf*cm, 80 in.*lbf }

    2. Return the carpet to its original position and attach the clips.