OIL PRESSURE SENSOR REMOVAL


  1. REMOVE NO. 2 ENGINE SERVICE HOLE COVER


    1. Detach the clips and fold back the carpet.

    2. A01BD0S

      Remove the 3 bolts and No. 2 engine service hole cover.

  2. DRAIN ENGINE OIL


    1. Remove the oil filler cap.

    2. Remove the oil pan drain plug and gasket, and then drain the engine oil into a container.

    3. Wipe the oil pan and oil pan drain plug.

    4. Install a new gasket and the oil pan drain plug.

      Torque:
      34 N*m  { 347 kgf*cm, 25 ft.*lbf }

  3. REMOVE OIL PRESSURE SENDER GAUGE ASSEMBLY


    1. Disconnect the oil pressure sender gauge connector.

    2. A01BCCJ

      Using a 27 mm deep socket wrench, remove the oil pressure sender gauge.