FRONT NO. 1 SPEAKER REMOVAL


  1. REMOVE FRONT DOOR WINDOW REGULATOR HANDLE ASSEMBLY (Without Power Window)


    1. A01BD2R

      Remove the front door window regulator handle shaft snap ring and the front door window regulator handle assembly.

  2. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY


    1. A01BGT1E01

      Remove the screw.

    2. Using a clip remover, disengage the 12 clips and remove the front door trim board sub-assembly.

      Tech Tips

      If a clip cannot be reached with the clip remover, pull on the lower trim to remove it.

  3. REMOVE FRONT NO.1 SPEAKER ASSEMBLY


    1. A01BFX5

      Disconnect the connector.

    2. Drill out the 3 rivet heads using a drill with a bit diameter of less than 4 mm (0.16 in.), and remove the front No.1 speaker assembly from the front door panel.

    3. Operate the drill along the rivet head circumference and cut out the flange.

      CAUTION:

      Be careful. The cut rivet is very hot.

      Note


      • Do not drill the rivet at an angle as this will cause damage to the drill and drill hole. Line up the drill and rivet, and carefully drill out the rivet head.

      • Be careful as the cut rivet will be very hot.

    4. After drilling out the flange, continue drilling to push out the shards on the drill.

    5. Using a vacuum cleaner, remove the rivet fragments and shavings from the inside of the door.