METER / GAUGE SYSTEM DATA LIST / ACTIVE TEST


  1. DATA LIST

    Using the GTS to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

    Note

    In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.


    1. Warm up the engine.

    2. Turn the ignition switch off.

    3. Connect the GTS to the DLC3.

    4. Turn the ignition switch ON.

    5. Turn the GTS on.

    6. Enter the following menus:


      1. for Combination Meter: Body Electrical / Combination Meter / Data List.

      2. for Engine: Powertrain / Engine and ECT / Data List / All Data.

      3. for ABS/VSC/TRC (w/ ABS): Chassis / ABS/VSC/TRC / Data List / All Data.

        Combination Meter
        Tester Display Measurement Item/Range Normal Condition Diagnostic Note
        Tail Relay SW Tail relay / OFF or ON OFF: Headlight dimmer switch in neither tail nor head position -
        ON: Headlight dimmer switch in tail or head position
        ODO/TRIP Change SW ODO/TRIP switch / OFF or ON OFF: ODO/TRIP switch released -
        ON: ODO/TRIP switch pushed
        Timer SW on Combination Meter*1 Clock switch / OFF or ON OFF: Clock switch released -
        ON: Clock switch pushed
        P-Seatbelt Buckle SW Front seat belt warning light request signal / ON or OFF OFF: Tongue plate (for front passenger side) inserted -
        ON: Tongue plate (for front passenger side) not inserted
        Vehicle Speed Meter Vehicle speed / Min.: 0 km/h (0 mph), Max.: 255 km/h (158 mph) Almost same as actual vehicle speed -
        Engine Rpm Engine speed / Min.: 0 rpm, Max.: 12750 rpm Actual engine speed -
        Coolant Temperature Engine coolant temperature / 0 to 127.5°C (0 to 261.5°F) After warming up: 75 to 100°C (167 to 212°F) -
        Reverse Range Switch (6MT)*2 Shift position R / OFF or ON OFF: Shift position except R -
        ON: Shift position R
        Oil Level SW Engine oil level sensor / OFF or ON OFF: Engine oil level low -
        ON: Engine oil level except above
        Water Level SW*3 Fuel sedimenter signal / OFF or ON OFF: Fuel sedimenter signal off -
        ON: Fuel sedimenter signal on
        Multi Display Select Switch*4 DISP switch / OFF or ON OFF: DISP switch released -
        ON: DISP switch pushed
        +B Voltage Value Battery voltage / Min.: 0 V, Max.: 25.5 V 11 to 14 V -
        Fuel Input Fuel input signal / Min.: 0, Max. 127.5 L Current fuel level displayed -
        Integrated value for Timing belt*3 Integrated value for Timing belt / 0 to 6556500 km Displays distance driven since last cleared -
        Ambient Temperature Outside temperature / Min.: -40°C (-40°F), Max.: 87.5°C (189.5°F) Almost the same as actual outside temperature -
        Oil Pressure Switch Engine oil pressure switch / OFF or ON OFF: Engine oil pressure not low -
        ON: Engine oil pressure low
        Fuel Filter Switch*3 Fuel filter signal / OFF or ON OFF: Fuel filter signal off -
        ON: Fuel filter signal on
        Turn Signal Switch (Right) Turn signal switch (right) / OFF or ON OFF: Turn signal switch (right) off -
        ON: Turn signal switch (right) on
        Turn Signal Switch (Left) Turn signal switch (left) / OFF or ON OFF: Turn signal switch (left) off -
        ON: Turn signal switch (left) on
        Hazard Flasher Switch Hazard warning signal switch / OFF or ON OFF: Hazard warning signal switch off -
        ON: Hazard warning signal switch on
        Driver Side Seatbelt Buckle Switch Front seat belt warning light request signal / ON or OFF OFF: Tongue plate (for driver side) inserted -
        ON: Tongue plate (for driver side) not inserted
        Parking Brake Switch Parking brake switch / OFF or ON OFF: Parking brake switch off -
        ON: Parking brake switch on
        Driver Side Door Driver side door / CLOSE or OPEN CLOSE: Driver side door close -
        OPEN: Driver side door open
        Door All (Except for Driver Side Seat) except driver side door / CLOSE or OPEN CLOSE: except driver side door close -
        OPEN: except driver side door open
        Turn Switch Signal (Full Turn) Turn signal switch (full turn) / OFF or ON OFF: Turn signal switch (full turn) off -
        ON: Turn signal switch (full turn) on
        Key Insert*5 Key unlock warning switch / OFF or ON OFF: No key in ignition key cylinder -
        ON: key inserted
        Driver Side Seatbelt Warning Buzzer Condition of driver side seat belt warning buzzer / OFF or ON OFF: Driver side seat belt warning buzzer does not sound at vehicle speed of 20 km/h (12 mph) or more when driver side seat belt unfastened The customized setting of the driver side seat belt warning buzzer is displayed.
        ON: Driver side seat belt warning buzzer sounds at vehicle speed of 20 km/h (12 mph) or more when driver side seat belt unfastened
        P-Seatbelt Warning Buzzer Condition of front passenger side seat belt warning buzzer / OFF or ON OFF: Front passenger side seat belt warning buzzer does not sound at vehicle speed of 20 km/ h (12 mph) or more when front passenger side seat belt unfastened The customized setting of the front passenger side seat warning buzzer is displayed.
        ON: Front passenger side seat belt warning buzzer sounds at vehicle speed of 20 km/h (12 mph) or more when front passenger side seat belt unfastened
        ECO Drive Indicator Zone*4 The condition of the eco driving indicator zone display / OFF or ON Customized setting displayed -
        ODO Display Time After IG OFF Setting Condition of the odo display time / 30 s, 60 s, 600 s or OFF Customized setting displayed -
        Lane Change Flashing Times Setting Condition of the lane change flashing time / 3, 5, 7 or OFF Customized setting displayed -
        Flasher Sound Tone Setting Condition of the flasher sound tone / Tone 1, Tone 2 or Tone 3 Customized setting displayed -
        Number of Trouble Code Number of DTCs currently stored 0 -

        • *1: for Segment Display Type

        • *2: for Manual Transmission

        • *3: Engine Type Diesel

        • *4: for Dot Display Type

        • *5: w/o Smart Entry and Start System

        Engine and ECT
        Tester Display Measurement Item/Range Normal Condition Diagnostic Note
        Engine Speed Engine speed / Min.: 0 rpm, Max.: 16383 rpm 650 to 750 rpm: When idling -
        Coolant Temp Engine coolant temperature / Min.: -40°C (-40°F), Max: 140°C (284°F) 75 to 100°C (167 to 212°F): After warming up -
        ABS/VSC/TRC (w/ ABS)
        Tester Display Measurement Item/Range Normal Condition Diagnostic Note
        Vehicle Speed Vehicle speed / Min.: 0 km/h (0 mph), Max.: 326 km/h (202 mph) Almost same as actual vehicle speed measured using speedometer tester -

  2. ACTIVE TEST

    Using the GTS to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.


    1. Connect the GTS to the DLC3.

    2. Turn the ignition switch ON.

    3. Turn the GTS on.

    4. Enter the following menus: Body Electrical / Combination Meter / Active Test.

    5. According to the display on the GTS, perform Active Test.

      Combination Meter
      Tester Display Test Part Control Range Diagnostic Note
      Speed Meter Operation Speedometer OFF, 0, 40 or 80 (mph)*1

        Acceptable range (mph): [Control range → Speedometer display]

      • 40 → 42.0 to 44.5

      • 80 → 83.1 to 87.1
      OFF, 0, 40, 80, 120 or 160 (km/h)*2

        Acceptable range (km/h): [Control range → Speedometer display]*12

      • 40 → 41.7 to 46.2

      • 80 → 83.4 to 88.4

      • 120 → 125.1 to 130.6

      • 160 → 166.2 to 173.2

        Acceptable range (km/h): [Control range → Speedometer display]*13

      • 40 → 41.0 to 45.5

      • 80 → 82.0 to 87.0

      • 120 → 122.8 to 128.3

      • 160 → 163.8 to 170.3

        Acceptable range (km/h): [Control range → Speedometer display]*14

      • 40 → 41.3 to 45.8

      • 80 → 82.6 to 87.6

      • 120 → 123.9 to 128.9

      • 160 → 165.2 to 170.2

        Acceptable range (km/h): [Control range → Speedometer display]*15

      • 40 → 40.2 to 44.5

      • 80 → 80.5 to 85.5

      • 120 → 120.7 to 126.2

      • 160 → 160.9 to 167.4
      Tacho Meter Operation Tachometer OFF, 0, 1000, 2000, 3000, 4000, 5000, 6000 or 7000 (rpm) -
      Fuel Meter Operation Fuel receiver gauge OFF, Sender E, Empty, Warning, 1/4, 1/2, 3/4, Full or Sender F -
      A/T Indicator Operation 1*3 Shift position indicator (P, R, N, D, 3, 2, L) OFF, L, 2, 3, D, N, R or P -
      Indicat. Lamp Doors All Open DOOR warning light OFF or ON -
      Front Passenger Side Seat Belt Front seat belt warning light OFF or ON -
      Driver Side Seat Belt Front seat belt warning light OFF or ON -
      Indicat. Lamp Charge CHARGE warning light OFF or ON -
      Indicat GLOW*4 GLOW indicator light OFF or ON -
      Indicat. Lamp Tail TAIL indicator light OFF or ON -
      Indicat. Headlamp Auto Leveling*5 Headlight beam level control system indicator light OFF or ON -
      Indicat. Lamp Fuel FUEL warning light OFF or ON -
      Indicat. Oil Pressure OIL warning light OFF or ON -
      Indicat. Lamp Water Level*4 SEDIMENT/FILTER indicator light OFF or ON -
      Indicat. ECONO*3 Eco driving indicator light OFF or ON -
      Indicat. Lamp Cruise*6 Cruise control indicator light OFF or ON -
      Indicat. Lamp Oil Level OIL LEVEL indicator light OFF or ON -
      Indicat. Lamp Brake BRAKE warning light OFF or ON -
      Indicat. Over Speed*7 Speed warning light OFF or ON -
      Indicat. Timing Belt*4 T-BELT indicator light OFF or ON -
      Master Warning*8 Master warning light OFF or ON -
      Indicat. SET*6 SET indicator light OFF or ON -
      Fuel Filter Indicator*4 SEDIMENT/FILTER indicator light OFF or ON -
      Cruise Indicator*6 Cruise control indicator light OFF or ON -
      LED Head Lamp Warning*5 LED headlight warning light OFF or ON -
      Turn Signal (Left) Indicator Turn Indicator light (LH) OFF or ON -
      Turn Signal (Right) Indicator Turn Indicator light (RH) OFF or ON -
      Smart System Indicator*9, *10 Smart entry indicator light OFF or ON -
      Smart System Warning*9, *10 Smart entry indicator light OFF or ON -
      Check Engine Indicator CHECK E/G warning light OFF or ON -
      Diesel Particulate Filter Warning*11 DPF indicator light OFF or ON -
      Brake Override Indicator Brake override system warning light OFF or ON -
      Water Temperature Meter Operation Engine coolant temperature receiver gauge OFF, Low, Normal or High -
      Meter Display 1 Multi-information display OFF, 6, 5, 4, 3, 2, 1, 0 or All -
      Meter Display 2 Multi-information display OFF, 9, 8 or 7 -

      • *1: for mph

      • *2: for km/h

      • *3: for Automatic Transmission

      • *4: Engine Type Diesel

      • *5: for LED Headlight

      • *6: w/ Cruise Control System

      • *7: for Middle East

      • *8: for Dot Display Type

      • *9: w/ Smart Entry and Start System

      • *10: for Segment Display Type

      • *11: for 1KD-FTV (w/ DPF)

      • *12: except Australia

      • *13: except 1KD-FTV, Manual Transmission (for Australia)

      • *14: for 1KD-FTV, Manual Transmission (for Australia)

      • *14: for Automatic Transmission (for Australia)