METER / GAUGE SYSTEM CUSTOMIZE PARAMETERS


  1. INSPECT T-BELT MODE DISPLAY (for Diesel)


    1. A01BI3JE01

      Turn the ignition switch ON.

    2. Turn the ODO/TRIP display screen to ODO, and turn the ignition switch off.

    3. While pressing the trip switch, turn the ignition switch ON and hold it for 5 seconds.

    4. Release the trip switch, then press the trip switch again within 5 seconds.

    5. Transfer to the T-BELT mode, and the following initial setting value is displayed.

      km : 15 (0,000 km) or 9 (0,000 mile)

      Tech Tips

      If the meter has been replaced before, the displayed value might not be the same as the initial setting value.

  2. REWRITING REPLACEMENT SETTING VALUE (for Diesel)


    1. Press the trip switch and rewrite the replacement setting value.

      Condition Setting value
      When a belt is replaced

      km : 15 (0,000 km)

      mile : 9 (0,000 mile)
      When a meter is replaced

      km : (15 (0,000 km)) - (Mileage when the meter is replaced.)

      mile : (9 (0,000 mile)) - (Mileage when the meter is replaced.)

      Tech Tips

      Every press of the trip switch adds 10,000 km or 10,000 mile and the meter returns to 10,000 km or 10,000 mile when 200,000 km or 200,000 mile is reached. If switch operation is not performed within 30 seconds, the setting value will not be changed. The display screen turns to "ODO", and the mode returns to the normal mode.

  3. T-BELT MODE COMPLETION (for Diesel)

    Note

    If the T-BELT mode is completed, even though belt replacement or meter replacement has not been performed, the T-BELT warning is reset.


    1. After setting the replacement setting value, hold the trip switch ON for more than 5 seconds, then release the trip switch.

    2. Check that the display is changed to "ODO" and the warning light goes off.

  4. SEAT BELT BUZZER ON/OFF SETTING


    1. Check that the ODO display is on, and turn the ignition switch off and then on. If another display is on, change it to the ODO display.

    2. Within 2 to 6 seconds after turning the ignition switch on, push the ODO/TRIP switch and hold it for 10 seconds or more.

    3. Following the table below, set the seat belt buzzer ON/OFF setting.

      Buzzer Operation
      Driver side seat belt buzzer

      Front seat inner belt assembly (driver side) OFF → ON

      (Seat belt unfastened → fastened)
      Front passenger seat belt buzzer

      Sit on the front passenger seat and front seat inner belt assembly (front passenger side) OFF → ON

      (Seat belt unfastened → fastened)

      Tech Tips

      The ODO/TRIP display changes from "b-on" to "b-off", entering the cancel mode.

    4. When in cancel mode, each time the ODO/TRIP switch is pushed, the setting switches between b-on (*1) and b-off (*2).

      Tech Tips

      *1: Cancel is invalid

      *2: Cancel is valid

    5. After changing the setting, the mode will be canceled by either not operating the switch for 10 seconds or more, or turning the ignition switch from ON to OFF.

      Tech Tips

      The setting can be reset when reconnecting the battery connector or removing/installing the meter connector (buzzer on).