OUTER REAR VIEW MIRROR DISASSEMBLY

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.


  1. REMOVE OUTER MIRROR LH (w/ Retract Mirror)


    1. A01BGFYE01
      Text in Illustration
      *1 Protective Tape
      *2 Moulding Remover D

      Push in the upper part of the mirror to tilt the mirror surface.

    2. Put protective tape on the outer rear view mirror assembly LH.

    3. Using moulding remover D, detach the 2 claws.

    4. Pull in the direction indicated by the arrow, detach the 2 guides and remove the outer mirror LH.

  2. REMOVE OUTER MIRROR RETRACTOR LH (w/ Retract Mirror)


    1. Remove the clamp.


      1. A01BGPYE01
        Text in Illustration
        *1 Tape
        *2 Clamp

        Remove the tape and clamp from the wire harness sub-assembly.

    2. Remove the base sub-assembly.


      1. A01BAJLE01
        Text in Illustration
        *1 Tape

        Remove the tape.

      2. A01BHV8E01
        Text in Illustration
        *a Cut here

        Cut the wire harness sub-assembly at the location shown in the illustration.

        Tech Tips

        A new wire harness sub-assembly is used for reassembly.

      3. A01BGSK

        Detach the 5 claws and remove the gasket.

      4. A01BF6U

        Using a T25 "TORX" socket wrench, remove the 3 "TORX" screws and base sub-assembly.

    3. A01BBA9

      Using a T25 "TORX" socket wrench, remove the "TORX" screw and base plate.

    4. A01BDVB

      Remove the 4 screws and body sub-assembly.

    5. A01BD17E01

      Remove the actuator sub-assembly.


      1. Detach the clamp.

      2. Move the rubber cover to disconnect the connector.

        Text in Illustration
        *1 Rubber Cover

      3. Pull out the wire harness sub-assembly as shown in the illustration.

      4. A01BDXB

        Remove the 3 screws and actuator sub-assembly.

      5. A01BA7IE01
        Text in Illustration
        *1 Protective Tape

        Using a screwdriver, detach the 2 claws and disconnect the 2 connectors.

        Tech Tips

        Tape the screwdriver tip before use.