ENGINE COOLANT TEMPERATURE SENSOR INSTALLATION


  1. INSTALL ENGINE COOLANT TEMPERATURE SENSOR


    1. Install a new gasket onto the engine coolant temperature sensor.

    2. Install the engine coolant temperature sensor.

      Torque:
      20 N*m  { 200 kgf*cm, 14 ft.*lbf }

    3. Connect the engine coolant temperature sensor connector.

  2. ADD ENGINE COOLANT


    1. Firmly tighten the drain plugs and fill the radiator reserve tank assembly with coolant to the top of the inlet.

    2. Loosen the bleeder plug of outlet housing.

    3. When air is bled and the coolant drains out, firmly install the bleeder plug.

    4. Add coolant up to the B line mark in the radiator reserve tank assembly and install the radiator cap.

      Coolant capacity
      Condition Capacity
      w/ rear heater 17.0 liters (18.0 US qts, 15.0 imp. qts)
      w/o rear heater 15.0 liters (15.9 US qts, 13.2 imp. qts)

    5. Warm up the engine.

    6. After the engine cools down check that the coolant level is between the LOW and FULL level marks.

  3. CHECK FOR ENGINE COOLANT LEAKS

    Click here