CRANKSHAFT POSITION SENSOR INSTALLATION


  1. INSTALL CRANKSHAFT POSITION SENSOR


    1. A01BAAT

      Apply a light coat of engine oil to the O-ring of the crankshaft position sensor.

    2. A01BD2A

      Install the crankshaft position sensor with the bolt.

      Torque:
      8.5 N*m  { 87 kgf*cm, 75 in.*lbf }

      Note

      Be careful that the O-ring is not cracked or jammed when installing the crankshaft position sensor.

    3. Connect the 3 wire harness clamps.

    4. A01BB55

      Connect the crankshaft position sensor connector to the vacuum pipe No.1.

    5. Connect the crankshaft position sensor connector.

  2. INSTALL VANE PUMP OIL RESERVOIR ASSEMBLY


    1. A01BBMI

      Install the vane pump oil reservoir assembly with the 2 bolts.

      Torque:
      8.0 N*m  { 82 kgf*cm, 71 in.*lbf }

  3. INSTALL ENGINE UNDER COVER NO.1 (w/ Engine Under Cover No.1)

    Torque:
    13 N*m  { 133 kgf*cm, 10 ft.*lbf }