ECM REMOVAL

CHECK INJECTOR COMPENSATION CODE

Note

When the ECM is replaced, all of the existing injector compensation codes must be input into the new ECM and the learning value of the fuel supply pump assembly must be initialized.
1. Check that the injection compensation codes of the fuel injectors installed on the cylinders match the ones registered in the ECM.
  - w/ DPF: Click here
  - w/o DPF: Click here
  If they do not match, correct the registered data.
  - w/ DPF: Click here
  - w/o DPF: Click here
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
REMOVE FRONT DOOR SCUFF PLATE RH
1. Detach the 5 clips and remove the front door scuff plate RH.
REMOVE FRONT SEAT ASSEMBLY RH
- for Hi-back Seat Type Click here
- for Low-back Seat Type Click here
- for Split Bench Seat Type Click here
REMOVE ECM
1. Fold back the floor carpet.
2. Remove the 3 bolts from the ECM.
3. Detach the 2 wire harness clamps from the No. 1 ECM bracket and No. 2 ECM bracket.
4. Raise the 2 levers while pushing the locks on the 2 levers, disconnect the 2 ECM connectors and remove the ECM.
  
  Text in Illustration
  
  *a Push
  
  *b Lock
  
  Note
  
  After disconnecting a ECM connector, make sure that dirt, water and other foreign matter does not contact the ECM connector.
REMOVE NO. 1 ECM BRACKET
1. Remove the 3 screws and No. 1 ECM bracket.
REMOVE NO. 2 ECM BRACKET
1. Remove the 2 screws and No. 2 ECM bracket.

Text in Illustration
*a	Push
*b	Lock