CRANKSHAFT POSITION SENSOR (w/ DPF) REMOVAL


  1. DISCONNECT VANE PUMP OIL RESERVOIR ASSEMBLY


    1. A01BE75

      Remove the 2 bolts and disconnect the vane pump oil reservoir.

  2. LOOSEN FAN PULLEY


    1. Loosen the 4 nuts from the fan pulley.

  3. REMOVE FAN AND GENERATOR V BELT


    1. A01BERGE01

      Remove the drive belt by rotating the tensioner pulley clockwise to loosen its tension with the pulley set bolt of the tensioner.

  4. REMOVE FAN PULLEY


    1. Remove the 4 nuts and fan pulley.

  5. REMOVE CRANKSHAFT POSITION SENSOR


    1. TYPE A:

      A01BFA6E01
      Text in Illustration
      *1 Clamp *2 Wire Harness Clamps (A)
      *3 Wire Harness Clamps (B) *4 Wire Harness Clamps (C)

      1. Detach the 2 wire harness clamps (B, C).

      2. Disconnect the crankshaft position sensor connector.

      3. Detach the crankshaft position sensor connector from the No. 1 vacuum transmitting pipe.

      4. Remove the clamp.

        Note


        • Make sure that no portion of the clamp remains in the clamp installation hole. If there is any portion of the clamp remaining, remove it.

        • Do not reuse the clamp.

      5. Remove the bolt and crankshaft position sensor.

      6. Remove the wire harness clamp (A) from the crankshaft position sensor.

    2. TYPE B:

      A01BGKUE01
      Text in Illustration
      *1 Clamp *2 Bracket (Clamp)
      *3 Wire Harness Clamps (A) *4 Wire Harness Clamps (B)
      *5 Wire Harness Clamps (C) - -

      1. Detach the 2 wire harness clamps (B, C).

      2. Disconnect the crankshaft position sensor connector.

      3. Detach the crankshaft position sensor connector from the No. 1 vacuum transmitting pipe.

      4. Remove the clamp.

        Note


        • Make sure that no portion of the clamp remains in the clamp installation hole. If there is any portion of the clamp remaining, remove it.

        • Do not reuse the clamp.

      5. Remove the bolt and bracket (clamp).

      6. Remove the bolt and crankshaft position sensor.

      7. Remove the wire harness clamp (A) from the crankshaft position sensor.

      8. Detach the 2 wire harness clamps from the bracket (clamp).