FUEL TANK INSTALLATION


  1. INSTALL FUEL SENDER GAUGE ASSEMBLY


    1. Install the fuel hose grommet onto the fuel tank assembly.

    2. Install a new fuel suction tube set gasket, the fuel pump gauge retainer and the fuel sender gauge assembly with the 8 bolts.

      Torque:
      4.0 N*m  { 41 kgf*cm, 35 in.*lbf }

    3. Install the fuel tank wire, No. 1 fuel evaporation tube sub-assembly, fuel tank main tube sub-assembly and fuel tank return tube sub-assembly onto the fuel sender gauge assembly.

  2. INSTALL FUEL TANK ASSEMBLY


    1. A01BAPVJ06

      Using the transmission jack, install the 2 fuel tank band sub-assemblies and fuel tank assembly with the 6 bolts.

      Torque:
      38 N*m  { 387 kgf*cm, 28 ft.*lbf }

    2. Connect the No. 3 parking break cable with the bolt.

      Torque:
      15 N*m  { 153 kgf*cm, 11 ft.*lbf }

  3. CONNECT NO. 3 FUEL HOSE


    1. A01BASMJ09

      Connect the No. 3 fuel hose, and tighten the clamp bolt.

  4. CONNECT FUEL TANK BREATHER TUBE


    1. A01BAK9J06

      Connect the fuel tank breather tube and clip.

  5. CONNECT FUEL TANK MAIN TUBE SUB-ASSEMBLY


    1. A01BAOKJ04

      Connect the fuel tank main tube sub-assembly with the clip.

  6. CONNECT FUEL TANK RETURN TUBE


    1. A01BGSXJ06

      Connect the fuel return tube Click here.

  7. CONNECT FUEL TANK WIRE


    1. A01BG32E03

      Connect the fuel tank wire.

  8. INSTALL PROPELLER SHAFT ASSEMBLY

    Tech Tips


    • Propeller shaft assembly for Super Long Wheelbase Click here

    • Propeller shaft assembly for Long Wheelbase Click here

  9. INSPECT FOR FUEL LEAK


    1. Perform the Active Test.


      1. Connect the intelligent tester to the DLC3.

      2. Turn the ignition switch ON.

      3. Turn the intelligent tester ON.

      4. Select the following menu items: Powertrain / ECD / Active Test.

      5. Perform the Active Test.

        Intelligent Tester Display Test Details Control Range Diagnostic Notes
        Test the Fuel Leak Pressurizes common rail internal fuel pressure, and checks for fuel leaks Stop/Start

        • Fuel pressure inside common rail pressurized to specified value and engine speed increased to 2,000 rpm when ON is selected

        • Above conditions preserved while test is ON