ENGINE FRONT OIL SEAL REMOVAL


  1. REMOVE ENGINE UNDER COVER NO.1 (w/ Engine Under Cover No.1)

  2. REMOVE FRONT SEAT ASSEMBLY RH (for Hi-back Seat Type)


    1. Perform the same procedure as above on the opposite side. Click here

  3. REMOVE FRONT SEAT ASSEMBLY RH (for Low-back Seat Type)


    1. Perform the same procedure as above on the opposite side. Click here

  4. REMOVE FRONT DOOR SCUFF PLATE RH

  5. REMOVE ENGINE SERVICE HOLE SUB COVER SUB-ASSEMBLY


    1. Roll up the carpet, and remove the engine service hole sub cover assembly.

  6. SEPARATE OIL COOLER OUTLET TUBE SUB-ASSEMBLY NO. 2 (for Automatic Transmission)


    1. A01BFCT

      Remove the 2 bolts and oil cooler outlet tube sub-assembly No. 2.

  7. REMOVE FAN & GENERATOR V BELT


    1. A01BGLOE03

      Remove the drive belt by rotating the tensioner pulley in clockwise direction to loosen its tension with the pulley set bolt of the tensioner.

  8. REMOVE CRANKSHAFT PULLEY


    1. A01BGPI

      Disconnect the oil pressure switching valve connector.

    2. A01BBYDE01

      Remove the bolt holding the crankshaft with SST.

      SST
      09213-58013
      09330-00021

    3. Insert the service bolt.

    4. A01BATVE01

      Remove the crankshaft pulley with SST.

      SST
      09950-50013   ( 09951-05010, 09952-05010, 09953-05020, 09954-05021 )

      Note

      Apply grease to the thread and tip of the SST (Center bolt) before use.

  9. REMOVE TIMING GEAR CASE OR TIMING CHAIN CASE OIL SEAL


    1. A01BFS9E01

      Remove the oil seal with SST.

      SST
      09308-10010
      09950-50013   ( 09957-04010 )
      09950-60010   ( 09951-00350 )

      Note

      Make sure that there is no damage such as scratch on the inner joint face of the crankshaft after the oil seal removal. If it is found, make the surface smooth by a sandpaper (#400).