CAMSHAFT REMOVAL

Note


  • When replacing the injectors (including shuffling the injectors between the cylinders), common rail or cylinder head, it is necessary to replace the injection pipes with new ones.

  • When replacing the fuel supply pump, common rail, cylinder block, cylinder head, cylinder head gasket or timing gear case, it is necessary to replace the fuel inlet pipe with a new one.


  1. REMOVE TIMING BELT

    Click here

  2. REMOVE INJECTOR ASSEMBLY

    Click here

  3. REMOVE CAMSHAFT TIMING PULLEY


    1. A01BBTF

      Remove the bolt and camshaft timing pulley while holding the camshaft with a wrench.

    2. A01BDDQE01

      Using SST, remove the camshaft timing pulley and set key.

      SST
      09950-40011   ( 09951-04010, 09952-04010, 09953-05010, 09957-04010 )
      09955-04150
    3. A01BFILE02

      Rotate the crankshaft approximately 90° counterclockwise from TDC to lower the piston.

  4. REMOVE NO. 2 TIMING BELT COVER


    1. A01BC0NE01

      Remove the nut, 4 bolts and No. 2 timing belt cover.

  5. REMOVE NO. 2 CAMSHAFT


    1. A01BHKIE02

      Position the key groove of the camshaft upward by turning the camshaft with a wrench.

    2. A01BHPHE01

      Uniformly loosen the 15 bearing cap bolts in several steps in the sequence shown in the illustration and remove the bolts.

    3. Remove the 5 bearing caps.

    4. A01BD22E01

      Remove the No. 2 camshaft.

  6. REMOVE CAMSHAFT


    1. A01BGX8E01

      Remove the camshaft.

  7. REMOVE CAMSHAFT SETTING OIL SEAL


    1. A01BB5Y

      Remove the oil seal from the camshaft.