MANIFOLD ABSOLUTE PRESSURE SENSOR ON-VEHICLE INSPECTION


  1. INSPECT AIR PRESSURE SENSOR


    1. Inspect the power source voltage.


      1. Disconnect the air pressure sensor connector.

      2. Turn the ignition switch to ON.

      3. A01BFA4E01
        Text in Illustration
        *a

        Front view of wire harness connector

        (Air Pressure Sensor)

        Measure the voltage according to the value(s) in the table below.

        Standard Voltage
        Tester Connection Switch Condition Specified Condition
        3 (VC) - 1 (E2) Ignition switch ON 4.5 to 5.5 V

        If the result is not as specified, inspect the wire harness and ECM.

      4. Turn the ignition switch off.

      5. Connect the air pressure sensor connector.

    2. Check the pressure.


      1. A01BDJ3

        Connect a pressure gauge to the air pressure sensor as shown in the illustration.

      2. Connect the intelligent tester to the DLC3.

      3. Turn the ignition switch to ON and turn the tester on.

      4. Enter the following menus: Powertrain / Engine and ECT / Data List / Air Pump Pressure (absolute).

      5. Check that the pressure displayed on the intelligent tester fluctuates when applying pressure to the pressure sensor with the pressure gauge.

        OK
        Pressure fluctuates in response to pressure applied with pressure gauge.

        Tech Tips

        The intelligent tester displays the air pump pressure (Air Pump Pressure (absolute)) as absolute pressure.

        If the result is not as specified, replace the air pressure sensor.