ECM INSTALLATION


  1. INSTALL NO. 2 ECM BRACKET


    1. Install the No. 2 ECM bracket with the 2 screws.

      Torque:
      3.0 N*m  { 31 kgf*cm, 27 in.*lbf }

  2. INSTALL NO. 1 ECM BRACKET


    1. Install the No. 1 ECM bracket with the 3 screws.

      Torque:
      3.0 N*m  { 31 kgf*cm, 27 in.*lbf }

  3. INSTALL ECM


    1. A01BDF8

      Install the ECM, connect the 2 ECM connectors and lower the 2 levers.

      Note


      • When connecting a ECM connector, make sure that dirt, water and other foreign matter is not stuck between the ECM connector and ECM.

      • Make sure that the 2 levers are securely lowered.

    2. Attach the 2 wire harness clamps to the No. 1 ECM bracket and No. 2 ECM bracket.

    3. Install the 3 bolts to the ECM.

      Torque:
      5.5 N*m  { 56 kgf*cm, 49 in.*lbf }

      Note

      Do not use an ECM that has been dropped or subjected to a strong impact.

    4. Return the floor carpet to its original position.

  4. INSTALL FRONT SEAT ASSEMBLY RH (for Hi-back Seat Type)


    1. Perform the same procedure as above on the opposite side. Click here

  5. INSTALL FRONT SEAT ASSEMBLY RH (for Low-back Seat Type)


    1. Perform the same procedure as above on the opposite side. Click here

  6. INSTALL FRONT DOOR SCUFF PLATE RH

  7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

  8. PERFORM INITIALIZATION


    1. Perform initialization procedures Click here.

      Note

      Certain systems need to be initialized after reconnecting the cable to the negative (-) battery terminal.