THROTTLE BODY REMOVAL


  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

  2. REMOVE ENGINE UNDER COVER NO. 1 (w/ Engine Under Cover No. 1)

  3. DRAIN ENGINE COOLANT

    CAUTION:

    Do not remove the radiator cap while the engine and radiator are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.


    1. Remove the radiator cap.

    2. Loosen the radiator drain plug and a cylinder block drain plug. Then drain the coolant.

      A01BFQWE01

  4. REMOVE FRONT SEAT ASSEMBLY RH (for Hi-back Seat Type)

    Tech Tips

    Use the same procedures described for the LH side. Click here

  5. REMOVE FRONT SEAT ASSEMBLY RH (for Low-back Seat Type)

    Tech Tips

    Use the same procedures described for the LH side. Click here

  6. REMOVE FRONT DOOR SCUFF PLATE RH

  7. REMOVE ENGINE SERVICE HOLE SUB COVER SUB-ASSEMBLY


    1. Roll up the carpet, and remove the 5 bolts and engine service hole sub cover.

  8. REMOVE INTAKE AIR CONNECTOR


    1. A01BGFJE01

      Slide the clamp and disconnect the No. 2 ventilation hose and vacuum hose. (A)

    2. Loosen the 2 hose clamp bolts. (B)

    3. Remove the 2 bolts and intake air connector. (C)

  9. REMOVE THROTTLE BODY ASSEMBLY


    1. A01BD19E01

      Disconnect the throttle motor connector. (A)

    2. Slide the clamp and disconnect the water by-pass hose. (B)

    3. Slide the clamp and disconnect the No. 2 water by-pass hose. (C)

    4. for Type A:

      Remove the 2 bolts and 2 nuts, and then remove the throttle body assembly. (D)

    5. for Type B:

      Remove the 4 bolts and throttle body assembly. (D)

    6. A01BA4J

      Remove the gasket from the intake manifold.