ENGINE REAR OIL SEAL REMOVAL


  1. REMOVE MANUAL TRANSMISSION UNIT ASSEMBLY (for Manual Transmission)

    Click here

  2. REMOVE AUTOMATIC TRANSMISSION ASSEMBLY (for Automatic Transmission)

    Click here

  3. REMOVE CLUTCH COVER ASSEMBLY (for Manual Transmission)


    1. A01BAUVE01

      Put matchmarks on the clutch cover assembly and the flywheel sub-assembly.

    2. Loosen each set bolt one turn at a time until spring tension is released.

    3. Remove the set bolts, and pull off the clutch cover assembly.

      Note

      Do not drop the clutch disc assembly.

  4. REMOVE CLUTCH DISC ASSEMBLY (for Manual Transmission)

    Note

    Keep the lining part of the clutch disc assembly, the pressure plate and surface of the flywheel sub-assembly away from oil and foreign matter.

  5. REMOVE FLYWHEEL SUB-ASSEMBLY (for Manual Transmission)


    1. A01BA6OE01

      Fix the crankshaft with SST.

      SST
      09213-54015   ( 91651-60855 )
      09330-00021
    2. A01BEL7E02

      Remove the 10 bolts and flywheel.

  6. REMOVE DRIVE PLATE AND RING GEAR SUB-ASSEMBLY (for Automatic Transmission)


    1. A01BA6OE01

      Fix the crankshaft with SST.

      SST
      09213-54015   ( 91651-60855 )
      09330-00021
    2. A01BCS0E01

      Remove the 10 bolts, spacer RR, drive plate and spacer FR.

  7. REMOVE ENGINE REAR OIL SEAL


    1. A01BGJ9E02

      Using a knife, cut through the oil seal lip.

    2. Using a screwdriver with its tip taped, pry out the oil seal.

      Note

      After the removal, check the crankshaft for damage. If it is damaged, smooth the surface with 400-grit sandpaper.