Tech Tips
Installation is in the reverse order of removal. But, the installation is indicated only when it has a point.
In the RH side, work in the same procedure as in the LH side.
See the components' drawing of rear door Click here.
REMOVE REAR DOOR WINDOW REGULATOR HANDLE ASSEMBLY
Pull off the snap ring with a shop rag and remove the regulator handle and plate.
REMOVE REAR ARMREST ASSEMBLY LH
Remove the 2 screws and rear armrest.
REMOVE REAR DOOR INSIDE HANDLE SUB-ASSEMBLY LH
Remove the screw and slide the bezel forward.
Disconnect the handle from the link, and remove the handle.
REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY LH
| *1 | Clips |
Using a screwdriver, remove the rear door trim board.
Tech Tips
Tape the screwdriver tip before use.
REMOVE REAR DOOR SERVICE HOLE COVER LH
REMOVE REAR DOOR GLASS WEATHERSTRIP OUTER
REMOVE REAR DOOR GLASS WEATHERSTRIP CHANNEL
REMOVE REAR DOOR GLASS RUN
REMOVE REAR DOOR REAR GUIDE BRACKET UPPER
REMOVE REAR DOOR GLASS SUB-ASSEMBLY LH
Remove the 2 bolts.
Pass the notch point shown in the illustration through, pull it out to the front side of the vehicle and remove the rear door glass.
REMOVE REAR DOOR GLASS CHANNEL SUB-ASSEMBLY LH
REMOVE REAR DOOR WINDOW REGULATOR SUB-ASSEMBLY LH
Remove the 3 bolts and regulator sub-assembly.
APPLICATION BODY GREASE
Apply MP grease to the sliding and rotating parts of the regulator sub-assembly.
REMOVE REAR DOOR WINDOW FRAME SUB-ASSEMBLY REAR LOWER LH
Remove the 2 bolts and rear door window frame.
REMOVE REAR DOOR LOCK ASSEMBLY LH
Disconnect the connector. (w/ Power door lock, w/ wireless door lock)
Remove 3 screws.
Disconnect the link.
Remove the rear door lock assembly.
REMOVE REAR DOOR LOCK ACTUATOR ASSEMBLY LH (W/ POWER DOOR LOCK)
Remove the 2 screws and rear door lock actuator assembly.
REMOVE REAR DOOR OUTSIDE HANDLE ASSEMBLY LH
Remove 2 bolts and outside handle assembly.