POWER WINDOW REGULATOR MOTOR (for RH Side) INSPECTION


  1. INSPECT POWER WINDOW REGULATOR MOTOR ASSEMBLY RH


    1. A01KHMTE01
      Text in Illustration
      *a Driving Axis
      *b Clockwise
      *c Counterclockwise

      Inspect the operation of the rear RH side power window regulator motor assembly.


      1. When adding the battery voltage to each connector terminal check that the motor operates smoothly.

        Measuring condition Operational direction

        Battery positive - Terminal 2

        Battery negative - Terminal 1

        		 Clockwise rotation toward driving axis

        Battery positive - Terminal 1

        Battery negative - Terminal 2

        		 Counterclockwise wind rotation toward driving axis

    2. Check the PTC operation inside power window regulator motor.

      Note

      Check should be done under the condition that the power window regulator and the door glass are installed.


      1. Set the DC 400 A probe of TOYOTA electrical tester to terminal 1 or 2 of the wire harness.

        Note

        Match the arrow mark of the probe with the current direction.

      2. Set the door glass at the fully-closed position.

      3. When approximately 60 seconds have passed after fully closing it, check the time that the current when pressing the power regulator switch UP again (at initial time) changes from approximately 16 to 34 A to less than 1 A.

        Standard
        Approx. 4 - 90 seconds

      4. When approximately 60 seconds have passed after the cutoff checking, check that the door glass will go down when the power regulator switch is pressed DOWN.