REAR BRAKE (for 2 Leading Shoe Type) INSTALLATION


  1. INSTALL REAR BRAKE DRUM (SINGLE TIRE TYPE)

  2. INSTALL REAR BRAKE DRUM (DOUBLE TIRE TYPE)

  3. ADJUST REAR DRUM BRAKE SHOE CLEARANCE


    1. Remove the shoe adjusting hole plug from the backing plate.

    2. Using a screwdriver, turn the adjusting nut until the wheel locks.

    3. A01KIIZ

      Turn the adjusting nut in opposite direction and make the shoe shrink to so that the drum can rotate easily. (w/ Automatic adjuster)

    4. A01KFJHE01
      Text in Illustration
      *a Expand
      *b Contract

      Turn the adjusting nut until the wheel turns freely. (w/o Automatic adjuster)

      Standard number of notches to be backed off
      5 notches

    5. Install the shoe adjusting hole plug to the backing plate.

  4. FILL RESERVOIR WITH BRAKE FLUID

  5. BLEED MASTER CYLINDER

    A01KECL

    Tech Tips

    If the master cylinder has been disassembled or if the reservoir becomes empty, bleed the air from the master cylinder.


    1. Disconnect the brake lines from the master cylinder.

    2. Slowly depress the brake pedal and hold it.

    3. A01KFNA

      Block off the outer holes with your fingers, and release the brake pedal.

    4. Repeat (b) and (c) 3 or 4 times.

  6. BLEED BRAKE LINE


    1. Connect the vinyl tube to the brake caliper.

    2. Depress the brake pedal several times, then loosen the bleeder plug with the pedal held down.

    3. At the point when fluid stops coming out, tighten the bleeder plug, then release the brake pedal.

    4. Repeat (b) and (c) until all the air in the fluid has been bled out.

    5. Repeat the above procedure to bleed the air out of the brake line for each wheel.

      Torque:
      11 N*m  { 110 kgf*cm, 8 ft.*lbf }

  7. CHECK FLUID LEVEL IN RESERVOIR

  8. CHECK BRAKE FLUID LEAKAGE

  9. INSTALL REAR WHEEL