1KD-FTV VACUUM PUMP REASSEMBLY


  1. INSTALL VACUUM PUMP BEARING


    1. A01KH2X

      Using a press, press in a new vacuum pump bearing to the vacuum pump shaft.

  2. INSTALL VACUUM PUMP SHAFT


    1. A01KHDKE01

      Using SST and a press, press the vacuum pump shaft into the vacuum pump housing.

      SST
      09608-04031
    2. A01KEKSE02
      Text in Illustration
      *1 Snap Ring Pliers

      Using snap ring pliers, install a new snap ring.

      Note

      Make sure that the snap ring is firmly installed in the groove.

  3. INSTALL VACUUM PUMP GEAR


    1. Install the woodruff key and vacuum pump gear to the vacuum pump shaft with the gear lock nut.

    2. A01KHSN

      Fix the vacuum pump gear in a vise between aluminum plates.

      Note

      Do not overtighten the vise.

    3. Fully tighten the gear lock nut.

      Torque:
      110 N*m  { 1125 kgf*cm, 82 ft.*lbf }

  4. INSTALL VACUUM PUMP BLADE


    1. Apply engine oil to the vacuum pump rotor.

    2. A01KHPOE03
      Text in Illustration
      *a Round End

      Install the vacuum pump rotor to the vacuum pump shaft.

    3. Apply engine oil to 5 new vacuum pump blades.

    4. Install the 5 vacuum pump blades with the round end facing outward.

      Note


      • Make sure that the vacuum pump blades are flush with the rotor surface.

      • Install so that the vacuum pump blade attaches on the housing.

  5. INSTALL VACUUM PUMP END COVER


    1. Apply engine oil to 2 new O-rings.

    2. Install the 2 O-rings.

    3. Install the vacuum pump end cover and temporarily install the 3 bolts.

    4. A01KFGV

      Using a 5 mm pin punch and hammer, tap in the 2 vacuum pump dowel pins.

    5. A01KEMW

      Fully tighten the 3 bolts.

      Torque:
      7.8 N*m  { 80 kgf*cm, 69 in.*lbf }

  6. INSTALL CHECK VALVE SUB-ASSEMBLY


    1. A01KI8H

      Install a new gasket and the check valve.

      Torque:
      74 N*m  { 749 kgf*cm, 54 ft.*lbf }

  7. INSTALL VACUUM PUMP UNION


    1. A01KG8EE02
      Text in Illustration
      *a Stopper

      Install 2 new gaskets and vacuum pump union with the union bolt.

      Torque:
      14 N*m  { 140 kgf*cm, 10 ft.*lbf }

      Note

      Check that the stopper of the vacuum pump union is securely held on the vacuum pump.

  8. INSPECT VACUUM PUMP


    1. A01KIMO

      Turn the vacuum pump gear counter-clockwise (left-hand turn, viewed from the gear side) and check for improper movement or torque change.