REAR AXLE SHAFT (for Single Tire) INSTALLATION


  1. INSTALL REAR AXLE SHAFT W/BACKING PLATE

    A01KI55

    1. Install the rear axle shaft with backing plate.

    2. Install the 4 washers and nuts.

      Torque:
      Ring gear size 8
      65 N*m  { 663 kgf*cm, 48 ft.*lbf }
      Ring gear size 9.5
      123 N*m  { 1254 kgf*cm, 91 ft.*lbf }

  2. INSTALL SPEED SENSOR REAR LH (W/ ABS)

    Torque:
    8.0 N*m  { 82 kgf*cm, 71 in.*lbf }

  3. INSTALL LH, FRONT OR UPPER REAR WHEEL BRAKE CYLINDER ASSEMBLY


    1. Install the wheel cylinder with the 2 bolts.

      Torque:
      10 N*m  { 100 kgf*cm, 7 ft.*lbf }

    2. Using union nut wrench 10 mm, connect the brake tube.

      Torque:
      15 N*m  { 155 kgf*cm, 11 ft.*lbf }

  4. INSTALL REAR BRAKE PARKING BRAKE SHOE LEVER SUB-ASSEMBLY


    1. Install the parking brake shoe lever with a new C-washer.

  5. INSTALL REAR BRAKE AUTOMATIC ADJUST LEVER LH


    1. Install the rear brake automatic adjust lever with a new E-ring.

    2. Install the tension spring.

  6. INSTALL REAR BRAKE SHOE

    Click here

  7. INSTALL STRUT SET, PARKING BRAKE SHOE, LH

    Click here

  8. CHECK FRONT BRAKE SHOE INSTALLATION

  9. INSTALL REAR BRAKE DRUM

  10. INSPECT REAR DRUM BRAKE SHOE CLEARANCE

  11. FILL RESERVOIR WITH BRAKE FLUID

  12. BLEED MASTER CYLINDER

  13. BLEED BRAKE LINE

    Click here

  14. INSPECT BRAKE FLUID LEVEL IN RESERVOIR

  15. CHECK BRAKE FLUID LEAKAGE

  16. INSTALL REAR WHEEL

    Torque:
    14 inch tire
    135 N*m  { 1377 kgf*cm, 100 ft.*lbf }
    15 inch tire
    170 N*m  { 1734 kgf*cm, 125 ft.*lbf }

  17. INSPECT AND ADJUST PARKING BRAKE LEVER TRAVEL

    Click here

  18. CHECK ABS SPEED SENSOR SIGNAL (W/ ABS)

    Click here