REAR AXLE HUB (for Just Low Double Tire) ON-VEHICLE INSPECTION


  1. ADJUST PRELOAD

    A01KGGIE01

    1. Remove the rear tire.

    2. Remove the rear axle shaft.

    3. Using SST, retorque the lock nut.

      SST
      09509-25011
      Torque:
      58 N*m  { 600 kgf*cm, 43 ft.*lbf }

    4. Snug down the bearing by turning the hub several times.

    5. Using SST, loosen the lock nut by until it can turned hand.

      SST
      09509-25011
      Torque:
      58 N*m  { 600 kgf*cm, 43 ft.*lbf }
    6. A01KHEJE01
      Text in Illustration
      *a 90°

      Using a spring tension gauge, measure the preload at the hub bolt.

      Preload (at starting)
      5 to 34 N (0.5 to 3.5 kgf, 1.19 to 7.7 lbf)

      Tech Tips

      Within the specified preload, align a lock nut mark with an axle housing mark.

      If preload is not within the specification, repeat the procedure above.

    7. A01KEYNE01
      Text in Illustration
      *1 Axle Housing
      *2 Lock Nut Plate
      *3 Bearing Lock Nut
      *a Correct
      *b Incorrect
      *c -0.2 to 0.9 mm
      *d 2 to 3 mm

      Measure the distance between the top surface of axle housing and the lock nut.

      Standard distance
      -0.2 to 0.9 mm (-0.008 to 0.035 in.)

      If not within the specification, reinstall the axle hub.

  2. INSPECT AXLE HUB AXIAL PLAY


    1. A01KGCX

      Using a dial indicator, check the axle hub axial play.

      Standard clearance
      0.1 mm (0.0039 in.) or less
    2. A01KGDX

      Install the rear axle bearing lock nut screw.

      Torque:
      4.5 N*m  { 50 kgf*cm, 43 in.*lbf }