DIFFERENTIAL CARRIER ASSEMBLY (for Ring Gear Size 10.5 inch) REMOVAL


  1. REMOVE REAR AXLE HOUSING FILLER PLUG

  2. REMOVE REAR AXLE HOUSING DRAIN PLUG

  3. DRAIN DIFFERENTIAL OIL

  4. REMOVE REAR AXLE SHAFT LH


    1. A01KETI

      Remove the 6 nuts and washers.

    2. A01KIOM

      Using a brass bar and a hammer, remove the 6 cone washers.

    3. A01KGE9

      Install the 2 service bolts, and turn each by turns.

    4. Remove the rear axle shaft LH.

    5. Remove the 2 service bolts from the rear axle shaft LH.

  5. REMOVE REAR AXLE SHAFT RH

    Tech Tips

    Use the same procedure for the LH side and RH side.

  6. REMOVE REAR AXLE SHAFT GASKET LH


    1. Remove the rear axle shaft gasket LH.

  7. REMOVE REAR AXLE SHAFT GASKET RH

    Tech Tips

    Use the same procedure for the LH side and RH side.

  8. SEPARATE REAR PROPELLER SHAFT ASSEMBLY

    Click here

  9. REMOVE REAR DIFFERENTIAL CARRIER ASSEMBLY

    A01KHWS

    1. Remove the 4 nuts, 4 washers, 8 bolts and the rear differential carrier assembly.

      Note

      Be careful no to damage the removal surface.

    2. Remove the rear differential carrier gasket.