PROPELLER SHAFT ASSEMBLY (for 2 Joint Type) DISASSEMBLY


  1. REMOVE UNIVERSAL JOINT SPIDER ASSEMBLY

    A01KIMGE01

    1. Place matchmarks on the flange yoke and sleeve yoke.

      Text in Illustration
      *a Matchmark
    2. A01KFE8

      Using a brass bar and a hammer, slightly tap in the bearing outer races.

    3. Using 2 screwdrivers, remove the 4 snap rings from the grooves.

    4. A01KIMCE01

      Using SST, push out the bearing from the propeller shaft.

      SST
      09332-25010

      Tech Tips

      Sufficiently raise the part indicated by (A) so that it does not come into contact with the bearing.

    5. A01KI86

      Clamp the bearing outer race in a vise and tap off the propeller shaft with a hammer.

      Note

      Do not tap the shaft.

      Tech Tips

      Remove the bearing on opposite side in the same procedure.

    6. Install the 2 removed bearing outer race to the spider.

    7. A01KFCHE01

      Using SST, push out the bearing from the yoke.

      SST
      09332-25010

      Tech Tips

      Sufficiently raise the part indicated by (A) so that it does not come into contact with the bearing.

    8. A01KEQA

      Clamp the outer bearing race in a vise and tap off the yoke with a hammer.