STARTER (for 2.7 kW Type) REMOVAL

Note

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.


  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

  2. REMOVE REAR DOOR SCUFF PLATE LH (for Double Cab)

    A01KF1Z

    1. Remove the 3 screws and rear door scuff plate.

  3. REMOVE REAR DOOR SCUFF PLATE RH (for Double Cab)

    A01KINS

    1. Remove the 3 screws and rear door scuff plate.

  4. REMOVE REAR FLOOR MAT (for Double Cab)

  5. REMOVE NO. 4 MAT SET PLATE (for Double Cab)

    A01KGPT

    1. Remove the 6 screws and mat set plate.

  6. REMOVE TRANSMISSION SERVICE HOLE COVER SUB-ASSEMBLY (for Double Cab)

    A01KIQM

    1. Remove the 12 bolts and service hole cover.

  7. REMOVE NO. 3 AIR HOSE


    1. A01KGB1

      Loosen the hose clamp shown in the illustration and separate the No. 3 air hose.

  8. REMOVE STARTER


    1. A01KGIQ

      Disconnect the connector.

    2. Open the terminal cap.

    3. Remove the nut and disconnect the wire harness.

    4. A01KHQ4

      Remove the bolt and separate the fuel pipe clamp.

    5. A01KF95

      Remove the bolt, nut and starter.