OIL PRESSURE SWITCHING VALVE (w/ DPF) INSTALLATION


  1. INSTALL OIL PRESSURE SWITCHING VALVE ASSEMBLY

    A01KH74E03
    Text in Illustration
    *1 O-ring

    1. Apply a light coat of engine oil to the O-ring of the oil pressure switching valve.

      Note

      If reusing the oil pressure switching valve, be sure to inspect the O-ring.

    2. Install the oil pressure switching valve with the bolt.

      Torque:
      10 N*m  { 102 kgf*cm, 7 ft.*lbf }

      Note

      Make sure that the O-ring is not cracked or jammed when installing the valve.

    3. Connect the oil pressure switching valve connector.

  2. ADD ENGINE OIL


    1. Add fresh oil and install the oil filler cap.

      Engine oil
      Item Oil Grade Oil Viscosity (SAE)
      w/ DPF

      • ACEA C2

      (Using engine oil other than ACEA C2 may damage catalytic converter)

      • 0W-30

      • 5W-30
      w/o DPF

      • G-DLD1, API CF-4, CF or ACEA B1

      • 5W-30


      • 10W-30


      • 15W-40


      • 20W-50
      Capacity
      Item Fill Amount
      Drain and refill with oil filter change 7.0 liters (7.4 US qts, 6.2 Imp. qts)
      Drain and refill without oil filter change 6.8 liters (7.2 US qts, 6.0 Imp. qts)
      Dry fill 7.7 liters (8.1 US qts, 6.8 Imp. qts)

  3. INSPECT FOR OIL LEAK


    1. Warm up the engine and inspect for oil leak.

  4. INSPECT ENGINE OIL LEVEL


    1. Warm up the engine, stop the engine and wait 5 minutes. The engine oil level should be between the dipstick low level mark and full level mark.

      If low, check for leakage and add oil up to the full level mark.

      Note

      Do not fill engine oil above the full level mark.