OIL PUMP DISASSEMBLY


  1. REMOVE TIMING GEAR CASE OR TIMING CHAIN CASE OIL SEAL

    Tech Tips

    There are 2 methods ((a) and (b)) to remove the oil seal.


    1. If the rear oil seal retainer is removed from the cylinder block:


      1. A01KENC

        Using a screwdriver and hammer, tap out the oil seal.

    2. A01KF32E01
      Text in Illustration
      *a Cut Position

      If the oil pump is installed to the cylinder block:


      1. Using a knife, cut off the oil seal lip.

      2. Using a screwdriver, pry out the oil seal.

        Note

        Be careful not to damage the crankshaft. Tape the screwdriver tip.

  2. REMOVE OIL PUMP RELIEF VALVE


    1. A01KIJQE01
      Text in Illustration
      *a Timing Pointer
      *b Clearance

      Place the timing belt case on wooden blocks.

      Note

      Be careful not to damage the timing pointer.

    2. A01KF57E01
      Text in Illustration
      *1 12 mm Hexagon Wrench

      Using a 12 mm hexagon wrench, remove the plug, gasket, spring and relief valve.

  3. REMOVE OIL PUMP DRIVE GEAR


    1. Remove the 8 screws, pump body cover, the drive and driven rotors.