WATER PUMP INSTALLATION


  1. INSTALL WATER PUMP ASSEMBLY W/O COVER

    A01KEF0

    1. Install a new gasket, the water pump and tension spring bracket with the 6 bolts.

      Torque:
      22.5 N*m  { 230 kgf*cm, 16 ft.*lbf }

  2. INSTALL TIMING BELT

    Click here

  3. REFILL ENGINE COOLANT


    1. Slowly fill the system with coolant.


      • Use of improper coolants may damage engine cooling system.


      • Use "Toyota Long Life Coolant" or equivalent and mix it with plan water according to the manufacturer's directions.


      • Using of coolant which includes more than 50 % [freezing protection down to -35°C (-31°F)] or 60 % [freezing protection down to -50°C (-58°F)] of ethylene-glycol is recommended but not more than 70 %.

      Note


      • Do not use an alcohol type coolant or plain water alone.


      • The coolant should be mixed with plain water (preferably demineralized water or distilled water).

        Capacity:
        Independent Front Suspension Rigid Front Suspension
        w/ Front heater

        10.7 liters

        (11.3 US qts, 9.4 Imp. qts)

        10.9 liters

        (11.5 US qts, 9.6 Imp. qts)
        w/o heater

        9.8 liters

        (10.4 US qts, 8.6 Imp. qts)

        10 liters

        (10.6 US qts, 8.8 Imp. qts)
        w/ Front and Rear heater

        11.5 liters

        (12.2 US qts, 10.1 Imp. qts)

        11.7 liters

        (12.3 US qts, 10.3 Imp. qts)

    2. Reinstall the radiator cap.

    3. Start the engine, and bleed the cooling system.

    4. Refill the radiator reservoir with coolant until it reaches the "full" line.

  4. CHECK ENGINE COOLANT LEAK