FUEL COOLER INSTALLATION


  1. INSTALL FUEL COOLER


    1. A01KGMK

      Install the fuel cooler with the 2 nuts.

      Torque:
      19 N*m  { 194 kgf*cm, 14 ft.*lbf }
    2. A01KH1V

      Install the 2 fuel hoses with the 2 clips.

  2. INSPECT FOR FUEL LEAK


    1. PERFORM ACTIVE TEST


      1. Connect the intelligent tester to the DLC3.

      2. Turn the ignition switch ON.

      3. Turn the intelligent tester ON.

      4. Start the engine.

      5. Enter the following menus: Powertrain / ECD / Active Test.

      6. Perform the Active Test.

        Intelligent Tester Display Test Details Control Range Diagnostic Notes
        Test the Fuel Leak Pressurizes common rail internal fuel pressure, and checks for fuel leaks Stop/Start

        • Fuel pressure inside common rail pressurized to specified value and engine speed increased to 2,000 rpm when ON is selected

        • Above conditions preserved while test is ON

      7. Make sure that there is no fuel leakage in the fuel system during the Active Test.