DRIVE BELT INSTALLATION


  1. INSTALL FAN AND GENERATOR V BELT


    1. A01KEJTE01

      For vehicles with A/C.


      1. Install the V belt.

      2. Tightening the bolt C, adjust the tension of the V belt.

      3. Tighten the bolts A and B.

        Torque:
        Bolt A
        65 N*m  { 650 kgf*cm, 48 ft.*lbf }
        Bolt B
        18 N*m  { 185 kgf*cm, 13 ft.*lbf }

      4. Check the tension of the V belt Click here.

    2. A01KEAGE01

      For vehicles without A/C.


      1. Install the V belt.

      2. Using a bar, adjust the tension of the V belt.

      3. Tighten the bolts A and B.

      4. Check the tension of the V belt.

        Torque:
        Bolt A
        65 N*m  { 650 kgf*cm, 48 ft.*lbf }
        Bolt B
        18 N*m  { 185 kgf*cm, 13 ft.*lbf }

      5. Check the tension of the V belt Click here.

  2. INSTALL V (COOLER COMPRESSOR TO CRANKSHAFT PULLEY) BELT NO.1


    1. A01KHWGE01
      Text in Illustration
      *1 Idler pulley

      Install the V belt.

    2. Tightening the bolt B, adjust the tension of the V belt.

    3. Tighten nut A.

      Torque:
      39 N*m  { 400 kgf*cm, 29 ft.*lbf }

    4. Check the tension of the V belt Click here.

  3. INSTALL VANE PUMP V BELT


    1. A01KEHTE01

      Install the V belt.

    2. Using a bar, adjust the tension of the V-ribbed belt.

    3. Tighten the bolts A and B.

      Torque:
      Bolt A
      72 N*m  { 730 kgf*cm, 53 ft.*lbf }
      Bolt B
      48 N*m  { 490 kgf*cm, 35 ft.*lbf }

    4. Check the tension of the V belt Click here.

  4. INSTALL ENGINE SIDE COVER SUB-ASSEMBLY LH (W/O TILT CAB CAB TYPE)

  5. INSTALL ENGINE SIDE COVER SUB-ASSEMBLY RH (W/O TILT CAB CAB TYPE)

  6. INSTALL ENGINE SERVICE HOLE SUB COVER SUB-ASSEMBLY (W/O TILT CAB CAB TYPE)

    Torque:
    11.5 N*m  { 115 kgf*cm, 8.5 ft.*lbf }

  7. INSTALL PARKING BRAKE SHOE LEVER SUB-ASSEMBLY (W/O TILT CAB CAB TYPE)

    Click here

  8. INSTALL TRANSMISSION FLOOR SHIFT ASSEMBLY (W/O TILT CAB CAB TYPE)



  9. INSTALL FRONT SEAT ASSEMBLY (DRIVER SEAT) (W/O TILT CAB CAB TYPE)


    1. Temporarily install front side of the front seat assembly RH with the 2 bolts.

    2. Install the 2 rear side bolts.

      Torque:
      39.0 N*m  { 398 kgf*cm, 29 ft.*lbf }

    3. Tighten the 2 front side bolts.

      Torque:
      39.0 N*m  { 398 kgf*cm, 29 ft.*lbf }

    4. Install the seat track cover.