ECD SYSTEM TC Terminal Circuit

DESCRIPTION

DTC output mode is set by connecting terminals TC and CG of the DLC3.

THE DTCs are displayed by blinking the SRS warning light.

WIRING DIAGRAM

A01KGP4E01

Tech Tips

When each warning light stays blinking, a ground short in the wiring of terminal TC of the DLC3 or an internal ground short in each ECU is suspected.

INSPECTION PROCEDURE

PROCEDURE


  1. CHECK WIRE HARNESS (DLC3 - AIRBAG ECU ASSEMBLY)


    1. A01KG6YE01
      Text in Illustration
      *a DLC3
      *b Airbag ECU Assembly

      Turn the ignition switch to the LOCK position.

    2. Disconnect the airbag ECU assembly connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard
      Tester connection Condition Specified condition
      DLC3 (TC) - A16-20 (TC) Always Below 1Ω

    NG

    REPAIR OR REPLACE WIRE HARNESS (TC of DLC3 - TC of AIRBAG ECU ASSEMBLY)

    OK

  2. CHECK WIRE HARNESS (CG of DLC3 - BODY GROUND)


    1. A01KEZXE60
      Text in Illustration
      *a DLC3

      Measure the resistance according to the value(s) in the table below.

      Standard
      Tester connection Condition Specified condition
      DLC3 (CG) - Body ground Always Below 1Ω

    NG

    REPAIR OR REPLACE WIRE HARNESS (CG of DLC3 - BODY GROUND)

    OK

  3. CHECK WIRE HARNESS (TC of AIRBAG ECU ASSEMBLY - BODY GROUND)


    1. A01KH4OE01

      Measure the resistance according to the value(s) in the table below.

      Standard
      Tester connection Condition Specified condition
      A16-20 (TC) - Body ground Always 1 MΩ or Higher

    NG

    REPAIR OR REPLACE WIRE HARNESS AND EACH ECU

    OK

    REPAIR AIR BAG ECU ASSEMBLY